Orifice Plate Dealers in Thane (6 products available)

We are well known for supplying of wide variety of Orifice Plate.

• Pressure Toppings :: For 1" to 16" - Flange Taps / Corner Taps. Above 16" - D x D/2

Orifice plate is the heart of the Orifice Meter. It restricts the flow and develops the Differential Pressure which is proportional to the square of the flow rate. The flow measuring accuracy entirely depends upon the quality of Orifice plate, its installation and maintains.

Scientific Devices offers a complete range of Orifice plates for a variety of flow conditions for mounting between flanges for Carrier Rings and with RJ Plate Holders for mounting between RJ Flanges.  Scientific Devices Orifice Flange Assemblies are made to AGA/ASME recommendations and are reliable means to flow measurement. Assemblies to other international Standards viz. ISO, BS, DIN etc. are also available. Scientific Devices Orifice flanges cover complete range of sizes pressure rating upto ASA 2500 of ANSI B16.36 as standard and dimensions as per other major international standard viz. – APL, MSS, BS and DIN etc. are also available on request. These flanges are available in various types such as Weld neck, Slip on, Screwed with facing FF, RJ, TG etc various types of tapping available are viz. Flange, Corner and D-D/2. Orifice Bore calculation can be carried out as per ASME MFC-3M, ASME 19.5 ISO 5167/BS1042, R.W. MILLER and L.K. Spink etc. Scientific Devices Orifice Flange Assemblies are supplied ready to install in pipelines complete with Studs, Nuts, Jack Bolts, Gaskets and Drain Plugs. Scientific Devices Orifice Flanges are manufactured in broad variety of materials to ASTM Standards viz.

• Sizes for Integral Design: 15, 20, 25, 40 MM
• Sizes for Flange Design: 25, 40, 50, 65, 80, 100, 150, 200, 250 MM

It is differential pressure type of flow meter, exactly reverse of rotameter. It is the most widely applied flow rate measuring device for fluid flows in pipes that require accurate measurement. Differential pressure flow meters have a change in flow cross section that can be described as a restriction placed in the flow line that causes the velocity of the flowing fluid to change. The difference in pressures between the two measurement locations of the flow meter is the result of the change in the flow velocities. The volume flow rate through the cross-sectional area is given by

The orifice plate with flange assemblies are employed for measuring the rate of flow or quantity of moving fluids like liquids, gases or vapours.When a device such as an orifice plate in a pipe line through which a fluid is flowing, as static pressure difference exists between the upstream side & the downstream side of the device is geometrically similar to one on which direct calibration has been made, the conditions of use being the same, the rate of flow may be determined from a knowledge of the circumstance under which the device is being used.

Orifice Plate, Electrode Type Level Gauge, Magnetic Float Gauge