Solenoids Dealers in Ambala (9 products available)

Dimension : 150 x 50 mm

Open Wound Solenoid Wide spaced heavy gauge copper wire coil to carry current upto 10A is mounted on a base with 4 mm socket terminals. A platform is supported across the centre of the coil to show the field by use of iron filings or a small compass. Dimension of coil 150 x 50 mm diam.

For Investigating MAgnetic Fields and the Force Between Conductors     Choose this large diameter Air Core Solenoid to invetigate the magnetic fields of a long coil or for use with the Current Balance Accessory. the interior diameter of the pheonlic coil former is slightly larger than 50mm so that it also fits over the cathode ray tube of the Mass of the Electron Apparatus. The solenoid is 15 cm long and has 570 turns of enamled #16 niclad copper magnet wire, allowing it to carry 5 A continuously, or 10 A intermittantly.  

It facilitates learning of induction and its dependence on total turns, turns per unit length, current flowing and cross sectional area of the coil. A set of 4 square section solenoids, two having a cross sectional area of 4000 mm2 and length of winding 295 mm. Turns per unit length ratio is kept 1:2 by close wounding, one by 380 turns anc' other is open wound by half i.e. 190 turns. The other two coi have a cross sectional area of 2000mm. The number of turns usei in each case is same as for larger coils, solenoids 325 mm (overa length), large coil 325 x 64 x 74 mm, small coils 325 x 45 x 55 mm.

We bring forth highly efficient Magnetising and Demagnetising Solenoid that features a 310mm long helical coil of DCC copper wire, which is mounted on a wooden board. The number of turns is marked on the Magnetising and Demagnetising Solenoid along with one meter connecting cable, fuses, push switch compass and soft iron rod of size 350 x 10mm. The internal diameter of the coil is 25mm approx. Our Magnetising and Demagnetising Solenoid is designed to be used on 230v mains supply.

To provide external magnetic field where required and to change the rate of magnetic flux passing through a coil. Consists of a plastic spool with windings of insulated copper. End plates have brass binding posts. Capacity 10 amperes when used intermittently and 5 amperes when used continuously.

A helical coil 310mm long of DCC copper wire mounted on a wooden board, number of turns marked, with one meter connecting cable, fuses, push switch compass & soft iron rod 350x10mm. Internal dia of coil 25mm approx. For use on 230V mains supply.

Dimension : 150 x 50 mm

OPEN WOUND SOLENOID Mounted on sturdy base with 4 mm socket terminal wide spaced heavy gauge copper wire coil to carry current upto 10 A. A platform is supported across the centre of the coil to show the field by use for iron fillings or a small compass. Dimension of coil 150 x 50 mm dia.