Asha Pura Corporation Pithampur, Dhar, Madhya Pradesh

PROCESS Slab Extractor And Primary Descaler:�Asha Pura Corporation uses a combination of the advanced Conarc Process and Thin Slab Casting technology, which facilitates the rolling of coils that are as thin as 1.2 mm with a width of 1550 mm. These are superior to commercial grade cold rolled (CR) coils, and are quite often a substitute for CR products in certain applications, due to their thinner gauges and finer surface quality.Reversing Roughing Mill:The 2 high reversing universal roughing mill supplied by United Engineering Corporation is equipped with a Vertical Edger which controls the width of transfer slab, thereby facilitating accurate width control of the rolled strips. The width of Slab is measured during rolling in roughing mill by the width gauge. Finishing Mill:The finishing stand is 4-High Steckel mill supplied by United Engineering Corporation. The mill is equipped with Hydraulic Automatic gauge control. The thickness and profile of the strip is measured during rolling with the help of X-Rays and Automatic gauge control facilities, supplied by M/s DAVY-LOEWY ENGLAND the world leaders in AGC equipments. The available on line datas are continuously monitored by computer which helps in producing HR Coils with best tolerances and surface finish. While producing the coils, the strip is coiled in the Steckel mill coilers housed in the furnaces above the roller tables provided on either sides of the finishing mill. This helps in maintaining sufficient temperature of the strip to facilitate rolling. To and fro rolling is done with the strip on either side of steckle mill.Laminar Strip Cooling:The strip cooling system is equipped with laminar cooling with precise control over rte of flow of water for cooling hot strip. This enables to achieve desired cooling temperature and metallurgical properties for the entire product.Down Coiler:The hot strip mill has a Hydraulic / Pneumatically operated Down Coiler with retreat to wrapper rolls during cooling with reference to head and movement i.e. jump control. This facilitates compact coiling without damaging the surface of strip by wrapper rolls even all high coiling speeds.Plates are ultrasonically tested and Mill Test Certificate provided along with the supplies.

Width : Max.2500 mm

Length : Standard Length or as required

PROCESS Ashoka corporation employs most modern manufacturing facilities where tested quality Hot Rolled Coils are slitted to desired width, before passing through a continuous pickling line. The pickled coils are then Cold Rolled on a 4 HI Mill, which ensures superb flatness.The Mill is fully computerized, using MMS Software with, non contact gauging system coupled with automatic gauge controller.The automatic gauge control system ensures uniform and desired thickness.When required the material is heat treated in bell furnaces in controlled inert atmosphere for obtaining required softness and maintain bright surface finish. The material then is skin passed, slitted and leveled and cut on an automatic Cut to Length line as per customer's requirement.For safety during transit, the material is wrapped with Polynesian cloth after giving suitable support and protection at the edges and on the bore. Coils and Bundles are suitably tagged for proper identification.   TYPICAL END-USES Automobiles, Furniture, Drums and Barrels, Containers, House Hold Equipment and General Engineering purposes.