RESPIRABLE COMBO DUST SAMPLER
168,000 Per Set
1 Set(s) (MOQ)
Respirable Dust Sampler
Get Price Quote
1 pices (MOQ)
Best Deals from Respirable Dust Sampler
APM 550 EL Respirable Dust Sampler
Get Price Quote
he APM 550 system is a manual method for sampling fine particles (PM2.5 fraction). Ambient air enters the APM 550 series samplers system through an omni-directional inlet designed to provide a clean aerodynamic cut-point for particles greater than 10 microns. Particles in the air stream finer than 10 microns proceed to a second impactor that has an aerodynamic cut-point at 2.5 microns. The air sample and fine particulates exiting from the PM2.5 impactor are passed through a 47mm diameter Teflon filter membrane that retains the fine particulate matter APM 550 EL keeps the sampling rate constant at 1m3hr by a microprocessor based electronic flow controller that automatically compensates for increasing pressure drop due to dust deposit on the filter. An ambient air temperature sensor and barometric pressure sensor have been provided to automatically provide temperature and pressure correction while reporting flow rate in volumetric flow units. An additional filter pressure sensor is also provided to continuously monitor and record the filter pressure and the system terminates the sample collection if the pressure drop across the filter exceeds a safe limit. The APM 550 EL has an in-built USB Flash memory based data logger that records Filter ID, air temperature, filter temperature, barometric pressure, flow rate, Coefficient of Variation (CV) and also totalizes and records the volume of air sampled. A PC based software is provided to download the data for audit and prepare an intelligent report highlighting all important information in a convenient graphical format.
Respirable Dust Sampler
Get Price Quote
technical specifications:- flow rate :- 0.9 – 1.4 m3 /min free flow particle size :- particles of 10 microns & below collected on filter paper holder. Spm bigger than 10 microns collected in a separate sampling bottle under the cyclone. sampling time :- 28 hours (maximum) sampling time record:- 0 to 9999.99 hrs. Recorded on a time totalizer. automatic sampling: - 24 hrs programmable timer to automatically shut off the system after pre set time interval. power requirement: - nominal 220 v, single phase, 50hz ac mains supply. size & weight :- 430 x 320 x 840mm.30kg
Respirable Dust Sampler
Get Price Quote
We are offering respirable dust sampler. Netel's model npm-hvs / r is designed to measure repairable suspended particulate matter in ambient air.it is used for collection of pm10 suspended particulate matter upto small as 0.1 micro size.it also has provision to collect samples of gaseous pollutants such as so2,nox, h2s,cl2 etc.
Respirable Dust Sampler
45,000 - 55,000 Per Piece
1 Piece(s) (MOQ)
Respirable Dust Sampler
33,400 Per Piece
1 Pack(s) (MOQ)
Respirable Dust Sampler Model APM 860
Get Price Quote
The APM 860 sampler uses an improved cyclone with sharper cutoff (D50 at 10 microns) to separate the coarser particulates from the air stream before filtering it on the glass microfibre filter. By using the APM 860, measurement of Respirable Particulate Matter can be done accurately and TSPM can also be assessed by collection of dust retained in the cyclone cup. Respirable Dust Sampler Model APM 860 Lata Envirotech Model APM 860 is designed and developed for monitoring of PM10 (based on cyclonic flow technique) meets most of the requirement of BIS 5182 (Part 23) 2006. The particulate matter 10 micron and below in size are directly The ambient air is sucked by a blower through corrosion free aluminum modular pipe and pass and it enters thorough a cyclone which divides the particulate matters in two fraction are below 10 micron and another above 10 microns. The Respirable dust (below 10 micron) directly gets deposited on filter paper and the coarser dust (above 10 microns) collected in the cup fitted under the cyclone. A time totalizer records the total running time of the blower. A programmable timer makes the instrument to stop and start as per desired intervals. A stabilizer is provided to provide constant power supply for smooth running of the system. The manometric systems indicate the rate of flow in cubic meter per minute which can be read directly on provided calibrated scale. Collected on filter paper and particulate matters above 10 microns are collected in cyclone cup. This instrument has got the provision for Gaseous Sampling Attachment suitable for sampling 4 gases viz SO2, NO2, O3 and NH3 simultaneously.Special Features : Brushless blower reduces equipment downtime and maintenance effort. Lockable casters and gaseous attachment. Improved cabinet design which is more sturdy and durable with SS hardware. Brushless blower reduces equipment downtime and maintenance efforts Significantly reduce Noise APM 860 comes with an in-built voltage stabilizer to compensate for voltage fluctuations. This model has been made more user-friendly, tool box within the instrument, softer handles. Owing to its modular design, APM 860 can be easily paired with a gaseous sampling attachment (for monitoring SO2, NOx, NH3, Ozone etc.) as gaseous sampling requires only a few LPM of air flow. This is possible through an attachable subsidiary unit LES 411. Kindly refer to respective brochures of LES 411.
Respirable Dust Sampler
Get Price Quote
1 Piece(s) (MOQ)
To collect ambient particulate samples of less than 10microns size.
Respirable Dust Sampler
Get Price Quote
Suspended Particles Matter( SPM) which is defined as particles less that 100 microns & Respirable Suspended Particle less than 10 microns have emerged as the most critical among all the criteria air pollutants & is caused by number of sources like Large, medium & small-scale industries, Road dust construction activities, house hold fuel cooking, waste burning, vehicular emissions etc.
Respirable Dust Sampler
Get Price Quote
Respirable Dust Sampler 22
Get Price Quote
We are offering respirable dust sampler. sle-rds103 suspended particles matter( spm) which is defined as particles less that 100 microns & respirable suspended particle less than 10 microns have emerged as the most critical among all the criteria air pollutants & is caused by number of sources like large, medium & small-scale industries, road dust construction activities, house hold fuel cooking, waste burning, vehicular emissions etc. in order to control the pollution, it is necessary to periodically monitor the air to determine the extent of pollution and to identify the source of emission sle-rds103 is designed to meet these needs. This model confirms to guidelines of central pollution control board. special features 1 low noise operations 2 brushless blower 3 portable for easy transportation 4 controlled flow 5 spm of particle size less than 100 microns 6 rspm of particle size less than 10 microns principles suspended particles in the air are sampled at constant rate of 0.9 to 1.3 m3 /min through the inlet of cyclone. By virtue of their momentum, particles greater than 10 microns are carried vertically upwards by the air flow and collected on a filter paper of 8 x 10 inch. technilcal specification flow rate 0.8 to 1.5 m3/min particle size up to 10 micron collected on filter and spm bigger than 10 micron collected in a separate collector cup blower continuous duty blower with brushless blower recommended filter gf/a(8” x 10”) for common use, epm 2000 for special research or equivalent time record 0 to 9999.99 hrs. Time totalizer records the running time in hours timer 24 hr programmable timer power requirement 220 volts, single phase ac sle-rds104 (nl) sharper cut off d50 system at 10 microns to separate coarser particles (> 10 microns) from air stream bfore filtering it on the glass micro fibre filter. special features 1 low noise operations. 2 brushless blower. 3 portable for easy transportation. 4 controlled flow. 5 spm of particle size less than 100 microns. 6 rspm of particle size less than 10 microns. 7 brush less & noise less blower without any belt. principle suspended particles in the air are sampled at 3 constant sampling rates of 0.9 to 1.4 m /min through the inlet of cyclone. By virtue of their momentum, particle greater than 10 microns are carried vertically upward by the air flow and collected on a filter paper of 8 x 10 inch. While coarse dust is collected in a cup placed under the cyclone. technical specification flow rate 0.9 to 1.4 m /min particle size up to 10 micron collected on filter and spm bigger than 10 micron collected in a separate collector cup under the cyclone accuracy + 2% of fsd blower continuous duty blower with noiseless & brushless without belt recommended filter gf/a (8” x 10”) for common use, epm 2000 for special research or equivalent time record 0 to 9999.99 hrs. Time totalizer records the running time in hours timer 24 hr programmable timer power requirement 220 volts, single phase, 50 hz ac main supply.
Respirable Dust Sampler
Get Price Quote
Get in touch with us for obtaining top quality and accurate Respirable Dust Sampler! We are a renowned Manufacturer, Supplier and Exporter of Respirable Dust Sampler in Delhi, India. Sturdy built, superb finish, hygienic and cost-effective are the highlights of our Dust Sampler, which is why it is extensively in demand. In order to meet the urgent and bulk demands of our buyers, we maintain a huge stock of Respirable Dust Sampler in our state-of-the-art warehouse.
Respirable Dust Sampler
Get Price Quote
Respirable Dust Sampler
Get Price Quote
Particle size: Below 10 microns collected on filter paper and bigger than 10 Micron will be collected in a separate sampling lid, through Cyclone separator. Flow Rate: 0.9 to 1.4m3/min.. Automatic Sampling: By- 24 Hrs Programmable Timer, Time Record Voltage Stabilizer: Auto shut off beyond (170–270) Volts. Filter: GF/A. (20x25)cms. Whatman Brand. Power Need: 220 V. 50 Hz. 1 Phase A.C. Gaseous Sampling: 0.3 to 3 LPM , Manifold, 4 Impingers with Ice Box. ACCESSORIES1. Impinger: 01 No.2. Filter paper 3. Dust Collector Bottles
Respirable Dust Sampler
Get Price Quote
The Sidekick sampling pump - a favorite with SKC customers. Reliability and simplicity make it a good entry level pump, whilst high build quality, means it won’t let you down. All models offer a wide flow range of 5-3000 mlmin, which means the Sidekick is suitable for dust and gas sampling projects. The lower flows are achieved with the constant pressure controller and low flow adaptor.
Respirable Dust Sampler
56,000 - 57,000 Per Piece
Respirable Dust Sampler
45,000 Per Piece
Respirable Dust Sampler
Get Price Quote
We are offering respirable dust sampler. Apm 460 bl is respirable dust sampler also called as pm 10 sampler is used for monitoring pm 10 in ambient air.
Respirable Dust Sampler
Get Price Quote
Instantaneous digital read out of dust concentration (No Weighing balance required), Highly sensitive in respirable dust range + 10mgm3, Highly sensitive in respirable dust range + 10mgm3, Choice of ranges for measurement, gives greater flexibility,Detachable sampling probe suitable for remote or inaccessible sampling.
