Gas Fired Hot AIR Generator Dealers in Mumbai (6 products available)

Airotherm is a combination of shell-in-shell and tube-in-shell type hot air generator. It has four concentric shells. The furnace shell has a blind end where the flue gases are reversed over the flame itself forming the 1st and 2nd pass. The 3rd pass is situated between the 2nd &3rd shell from where the flue gases, led via a duct, to the tube-in-shell type heat exchanger. The 4th & 5th pass are through tubes of the tube-in-shell heat exchanger. The burner assembly is bolted on a removable inner cover plate. The combustion air is led to an air register which is formed by the annular space of the inner cover and the outer cover. The air going for combustion is thus preheated. The fresh air has four passes to absorb heat from the flue gases. The 1st pass of the cold air enters around the 5th pass of the flue gases. Likewise all the subsequent passes of the air and flue are in counter current mode enabling maximum heat transfer. The final 4th pass of the fresh air which is at the last leg of the heat transfer path wraps around the furnace in circular path absorbing the heat attaining the required temperature for the process. The max temp for this model of heater is 300 The design of the heater is made simple and operator friendly.

Efficiency : 74 ± 2% on NCV

Temperature : Up to 320° C

Gas fired hot air generator Capacity: 1 Lkcal to 100 Lkcal Thermic Fluid Heater with Heat Exchanger.Fuel: Agro waste Wood Briquette Coal, Temperature:Temperature: Up to 320° C.

HAG SERIES Oil LPGNatural gas fired – 50,000 to 60,00,000 Kcalhr UNITHERM'S LPG/NATURAL GAS fired air heating system is designed specifically with large Industrial drying in mind. It's superior design, efficient performance and high fuel economy makes it a better buy than any other heater of its kind to achieve much lower drying costs than standard conventional ovens. The unit is easy to install, simple to maintain and highly economical to operate. The design is suitable for a maximum temperature of clean hot air at 300 dEG C IN INDIRECT Fired Design & 800 Deg C in Direct fired Units

Fully automatic. 2) Easy operation & fail proof system. 3) Packaged models. 4) Compact in design. 5) Caters to hot air requirements of any drier. 6) Record efficiency. 7) Economically cheapest clean hot air available instantly. 8) Low motive power required. 9) Replaces electricity, Steam, thermic fluid , media to generate hot air. 10) Drying Time & drying cost considerably reduced. NEOTECH's oil fired hot air generator model technology blocks comprise of an advanced shell in shell type radiant heat transfer section connected to a multiple pass shell & tube type convective hea exchanger.

Capacity Range : 600 Kg/hr – 10 Ton/hr

These Steam Boilers are available as Once through type, Shell type, Smoke Tube Water Tube Boilers. We offer Super Efficient Steam Boilers both IBR asIBR Boiler well SIB with numerous advantages in the Industrial world. three pass double helical design : allows preheated feed water to flow downwards through the finned economiser banks & passes to the radiant steaming zone. large furnace with low position : enables low heat release rate, rapid water circulation. submerged combustion chamber : results in excellent internal water circulation. separate tube sheet : eliminates stresses, prevents ligament cracks.

Clients' security is what we are concerned about and to eliminate this issue, we use leading technologies to make online and offline payments. Feel free to approach us, if seeking for top-of-the-line quality Oil And Gas Fuel Fired Hot Air Generator!