Programmable Counter Dealers in Thane (2 products available)

PRiCO (Programmble intelligent Counter) PRiCO provides a very cost - effective and reliable solution to many complex counting requirement. What sets PRiCO apart from the convention facet. SPECIFICATIONS : Counting modes » Up counting » Down counting » Quadrature counting » Bi-directional counting Display 7-digit, seven segment LED display (10mm height) » Counter/Totaliser/Batch: 7- digit display » Rate : 5- digit display » RPM : 6- digit display Range » Counter/Totaliser:Selectable least count 0.000001, 0.00001, 0.0001, 0.001, 0.01, 0.1, 1 » Rate: Rate per minute (RM) / Rate per hour (RH) user selectable. (minimum frequency for Rate mode is 10 Pulses/minute) » RPM: 10 RPM to 360000 RPM Set points » 3 user programmable set points. » SET1 , SET2 :Dedicated for COUNTER mode. » SET3 : User programmable for any one of COUNTER / TOTALISER /BATCH / RPM. Relay operating mode » Relay ON mode » Relay OFF mode » Pulse time mode     a) Time pulse repeat mode     b) Auto-reset mode Count inputs » Voltage pulse : 8 to 30 V DC amplitude from proximity switch, encoder. » Potential free contacts from limit switch, micro switch. Input frequency » 0 to 6 KHZ: In up / down mode » 0 to 3 KHZ: In quadrature mode / bi-directional mode. Sensor supply » 12 V DC, 60mA (+/- 10 %) Scale factor » Programmable » scale factor = X x 10Y     X = From 0.000001 to 9.999999     Y = 0, 1, 2, -1, -2, -3, -4, -5 Reset input » Manual / Front panel reset: with enable / disable facility » Remote/ Back panel / Electrical reset: User selectable     ( minimum time for remote reset is 10 ms. ) » Reset through programming mode: User selectable Relay outputs » Three Relays ( one relay for each set point ) » Relay1/ Relay2 for set1/set2 operation ( COUNTER ) » Relay3 for set3 ( COUNTER / TOTALISER / BATCH / RPM ) – Programmable » Relay ratings: Rated for 5 Amp at 230 V AC Memory retention » Upto 10 years Protection » Parameters     a) Password protected     b) Hardware protected (Dip switch setting) » Set points     a) Software protected (Through program configuration i.e. ‘SdF 3.’) Supply » 230 V AC (+/- 10%) Mounting » Panel mounting Weight » approximately 580 gms Operating temperature » 0° to 50° C Relative humidity » 10 - 95% non-condensing Overall dimensions » (All dimensions are in mm.)

programmable counter, Microprocessor Trainer Kit, Cool White LED Lamp