Mill Stands Dealers

Maximum paper roll diameter : 1400mm. Maximum support weight : 2T. Round-plate type manual brake, the web tension is adjusted at any time. Arm clamp and rotary structure set fixed torque clutch, operate safety. The structure is double rotary shaft with four arms; Support two paper mill rolls on both arms at the same time.

1.Equipped with four arms, support two sets of mill roll paper, non-stopping in changing the roll paper. 2.Hydraulic drive to lifting & lowering, clapping and correcting. 3.The paper tension is controlled by pneumatic disk brake and multi-points pneumatic brake. 4.Adopt expandable chuck to improve efficiency. 4.Maximum load-weight: 3T 1, Reel Stand driven by hydraulic 2, Kraft paper range Width:  Max:1900mm     Min:900mm Diameter: Max: 1400mm     Min:  350mm 3, Max load-bearing: 4000kg (One side) 4, Main roller dia.:  219mm 5, Pneumatic Source Pressure(Mpa): 0.4---0.8Mpa 6, Power: 380V 50Hz  Spec of hydraulic system: 1, Working Pressure(Mpa):16---18Mpa 2, Hydraulic Cylinder Range(Lift/Down): 100×440mm 3, Hydraulic Cylinder Range(Clamp/Loosen):  63×700mm 4, Hydraulic Station Motor Power: 4KW     Short Time(S2) Working Type Nominal voltage:380V 50Hz 5, Hydraulic Station Electromagnetic Valve Working Power:  220V     50 Hz  

Maximum diameter Dia 1500 mm Effective width 1400mm - 25mm Pneumatic brake control of web tension. Taper centre, stretch centre is optional. Hydraulic control of the lifting and lowering, clamping, releasing, right­ left movement.

Our hydraulic shaft less mill roll stand is featured by low maintenance, reduced wastage and user friendliness which in the long run is cost effective & economical. We can also produce them according to customers demands and requirements.

Mill Roll Stand, Corrugated Box Making Machines, Sheet Pressing Machin

Electrical Shaftless Mill Roll Stand, Sheet Pressing Machin

Hydraulic Shaftless Mill Roll Stand, Corrugation Sheet Pres