Kilns Dealers in Chennai

Rotary kilns are used to produce materials, such as cement clinker, alumina, magnesia, ceramsite and lime under high temperature. The TPD range from 1000 to 14000 and the Dia vary from 3Mtrs to 6.2 Mtrs.

Specification Working Temperature up to RT to 1400°C Tailor made sizes as per the customer requirement Capacity up to 5 tons per cycle Kanthal, Silicon carbide heating elements from Sweden/USA 1°C accuracy at dwell temp 1°C accuracy inside the temperature variation Rapid heating rate(1 to 20°C/min) programmable Suitable for advance ceramic products Reliable Imported / indigenized Insulation Indigenous VBCC Make phase control thyrister controller Nippon PID programmable digital temperature indicator cum controller Master slave method

Rotary Kilns are used to heat solids to the point where a required chemical reaction(s) takes place. The Rotary Kiln is basically a rotating inclined cylinder, solids retention time in the kiln is an important factor and is set by proper selection of diameter, length, speed, slope and the internal design.

Nose Cone for Windmill is made in three equal parts. It is based on FRP by contact molding process, using special types of glass reinforcement and polyester resins.  

Vertical Shaft Kiln, Mini Cement Plan

Rotary Kilns, Anode Furnaces, Rotary Granulator, Rotary Dryer

Chamber Kilns, Hot Chamber, Carbell Kiln, Holding Furnace, Ladle Preheate

Rotary Kiln for Andra Cements, Boiler Drum, ISA Smelt Furnac

Gas Fired Kiln

Tunnel Kiln Required For 75mtr to 100 mtr. Thanks & Reagrds

Industrial Kilns, Industrial Furnace

Vertical Shaft Kiln, Mild Steel Silos, Flash Cooler

Ceramic Kiln

Brick Kilns, Light Diesel Oil, Low Sulphur Heavy Stock Fue

Shuttle Ceramic Kiln, Skip Hoist, Roller Hearth Furnace, Powder Coating Ove