Fume Filters Dealers

IAFIPL Pulse Jet Bag Filter (CIRCULAR) offer excellent filtration efficiency for a wide variety of process dust and fume control systems. The low tangential (side) inlet technique allows larger dust particulate to separate from airstream below bags section rather than traveling through media array

There are two types of Metallic filters. All the metallic filters are arranged in a way that the contamination load is reduced to a very low extent. Once the unit is connected with the Blower, it will capture all the fumes vapours mist surrounding its suction hood inlet. All the fumes will be thoroughly filtered inside the system and clean air free of all hazardous particles will be released to shop floor from the outlet. Whenever cleaning of filters is required, switch off the system. Take the filters out of the unit and inspect them for any clogging deposition. All the filters can be manually cleaned and to clean them very light pressurized air should be used. Avoid excessive air pressure; it may tear off the filter media in pocket filters.

Designed primarily for welding applications where capture at source is not sufficient. Optimized to achieve highest possible capture rates where single or multiple units are used to achieve very low levels of particle concentration.

Welding Fume Filter, Oil Mist Collector

Welding Fume Filter, Ball Bearing, Saw Wires, Welding Cable

Fume Filters, Waste Reduction, Industrial Evaporator

Fume Filter, Smoke Extractor, Extraction Arm, PULSE JET FILTE

Fume Filters, Piping System, Electronic Gauges, Air Gaug

Filter for Fume Absorbe