Calibration
Get Price Quote
1. MECHNICAL: Caliper, Micrometer, Height gauge, Dial Indicator, Snap Gauge, Bore Gauge
Steel scale, Measuring tape.
A. MASTER INSTRUMENTS: Profile projector, Linear Height gauge, Electronic probe, Dial
calibration Tester, Height master, Caliper Checker, Sine Bar, Plain Plug gauge.
B. LIMIT GAUGES : Plain plug gauge, Snap gauge, Thread Plug gauge, Thread Ring
Gauge, Wear check Plug, Flash Pin Gauge
C. REFRENCE GAUGES : Slip gauge set, Measuring Pins, Length Bar, Filler Gauge, Ford
Cup/Flow cup, Test Sieves, Tri square, Angle Plate , Radius Gauge, Three Wire Unit,
Comparator Stand, Surface Plate , Bench Centre, Straight Edge.
D. MASS & VOLUME: Std. Weight Box, Dead Weight, Electronic/Physical Balance, Spring
balance, Specific gravity balance, Density Hydrometer, Volume (Flask, Burette, Pipette).
E. PRESSURE & VACUUM: Digital Pressure gauge, Pressure gauge, Dead weight tester,
Vacuum Gauge, Pressure Vacuum Transmitter/Manometer.
F. TORQUE & FORCE : Torque screw drive , Torque wrench, Push Pull Gauge, Rubber,
Hardness Tester, Tension Gauge, Tachometer, Rockwell Hardness Tester, Load cell
with indicator.
G. PROCESS : PH/Conductivity meter, Stop watch/Timer/Counter, Flow Meter(Water/Oil)
2. ELECTRICAL : Amp Meter, Volt meter, Sound level, Lux meter, Ohm Meter, Frequency Meter,
Watt Meter, Digital Millimeter, Inductance/capacitance meter, High Voltage tester, LCR meter,
Power supply (AC/DC), Clamp Meter ,Leakage Current, Power Factor meter.
3. TEMPERATURE: Temperature controller, PID controller, Temp Gauge, Thermocouple/RTD,
Glass thermometer, Temp Controller with sensor, Dry/Wet Thermometer, Hygrometer/RH
Meter, Refrigerator, Sterilizer/cold chamber, Envt. Chamber, Autoclave, Industrial
Oven/Furnace (Validation), RTD Simulator, Infrared Thermometer.
...more
Post Free Ad