THERMODYNAMIC SERVICES Sarvodaya Nagar, Kanpur, Uttar Pradesh

Thermax offers thermal oilthermic fluid heaters, fired by a wide range of fuels. Our heaters are available in both solid fuel firing as well as oilgas firing versions so that you get the advantage of economically available fuels.Thermal Oil Heaters range from 1 million kcalhr to 3 million kcalhr. All Thermal Oil Heaters are made with a coil type design ensuring instant heat.Capacity -1.0 to 3.0 million kcalhr, Fuel – Indian and imported coal, Kutch lignite, husk etc, TF outlet temperature up to 280 deg., New design incorporates.

Capacity : 1.0 to 3.0 million kcal/hr

Synthetic HT fluid formulated from selective synthetic base fluids to meet indirect heating of closed Heat transfer system, Mineral based HT fluid formulated from selective base stocks having good thermal stability, higher VI and very high flash point.

Assured accurate consistent downstream reduced pressure irrespective of fluctuations at inlet. Gives more latent heat, which is heat used in industrial equipments resulting in lower fuel consumption.Specially designed flow divider to ensure low noise levels.

Huskpac Ultra, the next generation rice husk fired boilers from Thermax, are designed to provide low cost heating with fuel efficiency as high as 74 %. Bubbling bed combustion, gives higher residence time to facilitate complete combustion, thus improving efficiency.Low cost heating, Bubbling bed combustion to enhance output and efficiency, Top Loading design to avoid nozzle failure & bulging of reversal chamber, Special ferrules to protect smoke tubes from abrasive husk ash, Special ferrules to protect smoke tubes from abrasive husk ash.

Capacity : 2 to 5 TPH, F & A 100 deg.C

High discharge per stroke, minimum wear and tear, Microprocessor based control with flow indicator totalizer, Weather proof with IP 65 protection suitable for outdoor installation Packaged pump easy to install, Components designed for high cycle life, Designed as per ASME section VIII div 1 –conformance to international, standard ensures quality design and longer life, Designed as per ASME SEC VIII Div 1- Conformance to international standard ensures quality design and longer life Adequately size to minimize pressure drop Designed with optimum separation velocity to get dry steam, Steam trap sized to handle condensate at low pressure, High pressure and capacity flash vessels is available on request. Not covered under IBR-hassle free installation Provided with safety valve and pressure gauge.

Zero leak, Low pressure drop valves for SteamThermic fluid application for isolation purpose,M IBR approved, Zero leakEnvironmental friendly, Maintenance free, Suitable up to 300 degree , Available in IBR & Non-IB.