Amco Engineering Works Goa Bagan, Kolkata, West Bengal

Reusable SS 100 mesh / 149 micron std Aluminium die cast nut Steel cap / support tube Continuous epoxy bond Suitable for hydraulic/mineral oil Max. Working temp. 80oC     Amco Filter Suction Strainer Elements are designed for installation into suction lines of pumps. Extra caution should be taken to ensure that the suction elements are always mounted below the minimum oil level of the reservoir. Standard models have nominal filtration ratings of 74 or 125 microns. The suction strainer elements can also be supplied with a bypass valve to reduce high pressure drops caused by contaminated elements or high viscosity fluids during cold starting. The bypass valve opens at 3 psi. For best results, suction strainer elements should be sized for clean element pressure drops off no higher than 0.5-.07 psi.Amco Filter suction Strainer Elements are manufactured using stainless steel wire screen media. Suction strainer elements are only intended to protect hydraulic pumps against catastrophic failure caused by coarse contaminants. Suction strainer elements should be inspected and cleaned regularly. Suction strainer elements should not be used as the only filtration elements in a hydraulic system. Pressure filters and return line filters, with reasonable dirt holding capacity, must be installed to provide protection against component damage caused by fine contaminants.

We are one of the reliable manufacturers and suppliers of a superior quality range of Filter Equipment. These can extract very small contaminants and are used for protection of fine filters in primary filtration process. Moreover, these are also known for features like reliable performance high filtration capacity, durable finish standards and easy maintenance. Owing to such features, these are extensively used in Pharmaceutical, Clean Rooms, Chemical Industries and General Air Conditioning & Ventilation System. Available types are as follows: 10 to 15 microns pre filters: Primary filters Used for protection of fine filters Manufactured from HDPE 3 ply Water washable 5 microns fine filters: Secondary filters Used for the fine filtration Manufactured from HDPE 3 ply Manufactured from HDPE mono filaments oven meshes in 5 ply Stitched together Water washable

  Over 300 models of air-oil separator elements are available utilizing a cylindrical or pleated design of micro glass with a variety of flanges, gaskets and kits. Air flow capacities up to 3000 CFM / element with 0.3- 10-micron aerosol selectivity and up to 99.9% removal efficiency are available. These elements are limited, however, to 225oF operating temperature at 50 PSI DP maximum differential pressure. A variation of these air-oil separator elements are the Mist Eliminator Elements which are used for the elimination of ale oil smoke and mist from mechanical and rotary vacuum pumps. Available in 5,10,25,40,60,100,150,200 and above Microns

Resin impregnated Cellulosic Paper Filter media Depth Nominal Filtration Available in 5, 10, 25, 35 nominal micron ratings

Hydraulic Filter elements of paper & Glass Fiber Media: - Resin impregnated Cellulosic paper media Depth Nominal Filtration Available in 5, 10, 25, 35 nominal micron ratings

Available in different thickness and configurations High efficiency filtration with chemical/corrosive resistance, chemical plants, air conditioning and ventilation systems etc. 3/5 layers of high density polyethylene /polypropylene mesh stitched and pleated to provide maximum filtration area in the space provided housed in a metallic frame. Pleats are uniformly separated by metallic spacers 2-3 m/s 4 mm wg. 16mmwg. 82% (down to 10 micron)