Hopper Heaters Dealers in Kolkata

The heater in ESP hopper are provided to avoid clinker formation of the ash being collected at the bottom of ESP. Whereas the heaters provided at the shaft and support insulators are required to maintain the temperature above dew point which lies between 80-115 deg C. If temperature falls below the range as mentioned there will be a continuous tracking of electrical field over the surface of insulator which will result into damage of insulator and non availability of field for collecting the fly ash. We in Heatco after continuous R & D detected the importance of the Heating Elements for ESP and as per the requirement developed the Heaters for its smooth functioning. We are providing some of the types of heating elements provided at hopper and support and shaft insulator.

Hopper Heater: The suspended particulate matter (SPM) from the Flue Gas Strem passing through the ESP's are collected in the hoppers below. These are then removed from the ESP and carried by Conveyors of various designs. However, choking and accumulation of this dust sometimes happens in the hoppers due to the presence of moisture and low temperature in the hoppers. This adversely affects the performance of an ESP. As such, hopper heaters are installed in the hopper walls which helps in maintaining the temperature in the hoppers, thereby avoiding any choking or acumulation. Insulator Heaters: The successful performance of an ESP is depending on many factory including the temperature inside the ESP. Air Ingress takes place in the ESP's through the openings of the Insulators. Heaters are installed here to heat the entering air thereby maintaining the temperature within the ESP.

Hopper Heaters, Mechanical Spares, Electrical Spare Parts, ESP Insulator

ESP Hopper Heaters, Heat Exchangers, Tube Bundles, Condense

ESP Hopper Heater, Shaft Insulator Heater, Bracket Fin Heate

ESP Hopper Heaters, Tubular Heaters, Finned Tubular Heate