Track Rollers Dealers

It consists of two rectangular steel tubing frames. One is stationary, the other is movable. it is supported in a nyalguide sliding block and arcuate bar system, and has ab idler roller at either end. The web can be fed over the Tracking Roller Assemblies in A ‘U’ shaped path, reversing its direction of travel, or through the Tracking Roller Assemblies in a ‘Z’ configuration, maintaining the same direction of travel. It is insensitive to attitude and can even be mounted upside down. Solidly supported on all four corners by nylaguide bearings, it is not subject to deflections caused by cantilever stresses. Radial bearings are sealed, and linear bearings are self – cleaning and self – lubrication. The unit therefore requires no maintenance.

We are the leading dealers, Importers and Stockists of Track Roller, Idler Assy, Track Link, Track Shoe Plate, Track Pin and Bush, Sprocket, Track Shoe Bolt Nuts and Track Guard parts for Tata Hitachi, L&T Komatsu, BEML Dozer, Caterpillar, Poclain, etc.   

    "COLT" Track Rollers are life time lubricated and maintenance free.    Forged from deep hardening alloy steels.     Shells are properly hardened in order to achieve inner strength and again heat treated to achieve hard surface with maximum case depth. This ensures tread life is equal to links wear life.     Shell treadpath and flanges are re-buildable     Shafts are made from high carbon steel and again properly heat treated to ensure maximum life.     Shafts are sophisticated machined in order to ensure maximum Bush life.     Bi- metallic type bushes are used. Their external steel shell , are resistant to any type of deformations and keep their shape perfectly. The inner layer of brass is an excellent anti-friction.     End collars are made of good quality ductile cast iron which offers maximum inner strength and are able to absorb maximum impact and shock loads without cracking. Thrust surfaces are induction hardened for better axial load capacity.     Superior quality seal groups (refer to seal group section) are used in order to avoid leakage problems and improving shelf life

Track rollers are self-retaining, single or double row units with particularly thick-walled outer rings. These bearings can support axial forces in both directions as well as high radial forces. The bearing outer rings have a crowned or cylindrical outside surface. Designs with a crowned outside surface are used where there is misalignment in relation to the raceway and edge stresses must be avoided. The track rollers are available with an inner ring, with a stud and with a plastic tyre on the outer ring. INA track rollers LR52 and LR53 – now available in X-life quality INA track rollers series LR52 and LR53 are now available in X-life quality. They can now transmit higher radial loads and have a longer rating life thanks to the optimized internal design.The external dimensions of the new bearings have not changed, which means they can replace earlier bearings without difficulty.

We are importing and representing KTSU Japan for these product in India, Apart from prescribed quality standards, KTSU Japan Rollers are FRICTION WELDED, a salient feature available only to state of art technology plant, and that too a very few in world.