Refinery Plants Dealers in Ahmedabad (22 products available)

WyunaSep Hydro cyclone separators are one of the best ways to separate two non-mixing liquids. Almost any hydrocarbon oil and most non-hydrocarbon oils such as corn, orange, or other vegetable oils may be separated from water in a satisfactory manner. We manufacture our Waste Refinery Plant, as per the leading industrial norms and standards. High Performance : WyunaSep liquid /liquid hydro cyclones can treat emulsions with oil droplets below 15 microns. (50 to 100 microns for competitor's systems) The most reliable oil separation performance. Units are not affected by debris build up or inadequate maintenance, as can occur with other systems. The treatment system is closed hence there is no equipment smells or vapour emissions.   Low Maintenance : No plates, or Hopper to clean leading to lower yearly maintenance costs. No closely packed plates to block. No algae chemical dose required. No large stagnant volumes. All our systems use high quality stainless steel piping and frames. No occupational health & safety issues like with plate pack cleaning. Easy Installation/Use : Our most models are easily manoeuvrable and will fit into confined or hazardous spaces. Pressurized oil and water discharge allows flexibility in site location and savings because re-pumping is not required. Standard systems are fully pneumatic with no electrical connections. This greatly simplifies and reduces the cost of installation.   Operational Flexibility : Has the ability (via recycle option) to batch treat very difficult emulsions, and discharge water when oil content is below limits. With low cost recycle option, equipment has the ability to meet future oil discharge limits without additional capital expenditure. Removed oil is stored in large above (or below) ground decanting containers, extending the time between oil waste collections. Because our systems use skimmers, oil layers do not accumulate in the effluent pit so little or no oil will escape if the pit accidentally floods.   Specifications : Separate oil from wastewater as an industrial pre-treatment system prior to directing the water to sewer or other disposal. Separate oil from circulating water or other aqueous phase systems to remove the oils so that the stream can more economically be reused or so that the oil in the water stream does not cause problems elsewhere in the system by fouling heat exchangers or catalysts. Separate oil from water so that the water may be purified and reused or recycled. Can be used either internally in chemical plants or oil refineries or in plant or refinery outfall streams. Industrial pre-treatment of waste streams prior to disposal to sanitary sewer systems Features : Foot Print - Compact, 10% the size and weight of conventional systems. -2 to 24 m3 = 1 to 1.5 m2 area. Oil content – single cycle <20 ppm or recycle + DHRR <5ppm in two stage Clean water with no chemicals. Effluent can be recycled for continuous treatment. Lowest cleaning & maintenance bills. Lowest repair & parts replacement bills. Lowest total ownership cost over 2 to 4 years. Ensure discharge compliance. Satisfies Regulatory authorities. More likely to meet tougher new Regulations. You can get on with your business. Fully pneumatic. Complies with Standards for hazardous Waste Zones.

• Application: Sunflower Oil, Cotton Seed Oil
• Approx. Price: Rs 24.5 Lakh / Unit
• Capacity: 5-20 ton/day
• Automation Grade: Automatic, Semi-Automatic

Irrespective of it being a wholesale or retail order, we can deliver it timely. We have shipping resources on reserve all year round to make sure delivery of our items is bother free. Our dedicated staff is always on their toes to make certain that the raw material used is of high grade and certified by the experts as well.

• Capacity: 60-100 ton/day
• Usage/Application: Cassava, Soybean, Peanut, Sunflower, Cotton seed, Palm fruit etc. Oil extractor plant
• Automation Grade: Semi-Automatic
• Features: Oil refining
• Design: As per customer requirement
• Material: SS 304,SS 316 or Mild Steel 

• Capacity: 2 MT / Day to 50 MT

Description: Introduction:- We are pioneer in Used Oil Re-Refining Plant Manufacturing, Erection and Installation. Lubricating oil after prolonged use in the engine’s crankcase gets degraded due to oxidation, presence of water, carbon particles, oxidation sludge etc. This oil, if not replace, will cause failure of the engine. The disposal of used oil is a major environmental problem unless it is processed safely as the indiscriminate disposal will cause pollution to water bodies and land fillings. The proposal is to manufacture petroleum lubricant oils and other petroleum based products, from waste / used oils and manufacture of lubricants to the specification required to satisfy the International specifications. General Process for Used Oil Re-Refining:- The process involves below different stages. Used Oil Receiving Centrifuging / Filtration Preparation of Feedstock Dehydration Column Lube Oil Distillation Column Bottom Residue Collection Clay Treatment/Decolourisation Filtration Testing Capacity Available:- 2 MT / Day to 50 MT / Day Used (Waste) Oil Re Refining (Recycling) Plants.

We are pioneer in Used Oil Re-Refining Plant Manufacturing, Erection and Installation. Lubricating oil after prolonged use in the engine’s crankcase gets degraded due to oxidation, presence of water, carbon particles, oxidation sludge etc. This oil, if not replace, will cause failure of the engine. The disposal of used oil is a major environmental problem unless it is processed safely as the indiscriminate disposal will cause pollution to water bodies and land fillings. The proposal is to manufacture petroleum lubricant oils and other petroleum based products, from waste / used oils and manufacture of lubricants to the specification required to satisfy the International specifications. General Process for Used Oil Re-Refining:- The process involves below different stages. Used Oil Receiving Centrifuging / Filtration Preparation of Feedstock Dehydration Column Lube Oil Distillation Column Bottom Residue Collection Clay Treatment/Decolourisation Filtration Testing Capacity Available:- 2 MT / Day to 50 MT / Day Used (Waste) Oil Re Refining (Recycling) Plants.

Since the early days, man has been using common salt as food additive in the food to improve its taste and to meet the physiological requirements of the human body. During the coarse of development of the society as man needed a wide range of materials to meet its needs it became necessary to develop range chemicals that would meet these requirements. Salt became an important ingredient and raw material for manufacture of a large number of these chemicals. Salt is reported to have over 14,000 uses. Some of the major users are

• Application: Lube Oil
• Automatic Grade: Semi-Automatic
• Country of Origin: Made In India
• Power Consumption: 150 HP
• Capacity: 10000 L/Batch
• Brand Name: Joyam
• Average out put oil rate: 82%
• Structure Form: Vertical (easy cleaning and maintenance)
• Mode of cooling: Recycled water cooling
• Raw material: Motor oil,Waste tire crude oil,Plastic crude oil

Linseed oil, raw and refined (second revision), Methods of sampling and test for oils and fats:Part 2 Purity tests: Sec 21 Test for detection of animals fat in vegetable oiland fats and vice-versa by GLC(fourth revision). Methods of sampling and test for oils and fats :Part 3 Analysis by gas liquid chromotography

e-waste refinery precious metal recovery plants

We are offering edible oil refinery & vanaspati plant for sale continuous-oil-refinery.jpg running condition complete plant for sale consisting followings capacity 150 tpd continuous degummingneutralizing 50 tpd three stage alfa laval short mix bleaching sections 100 tpd continuous with plfs deodorization continuous 75 tpd and 100 tpd alfa laval dry-fractionation system of palm oil 150 tpd continuous with rotary vacuum filter storage more than 1400 tons thermax steam boilers 8 tph and 4 tph , thermic fluid heater thermax 10 kcal and isotex 4 kcal its include autoclaves, coolers, batch vessels, pp and ci filter presses, hydrogen sections, chilling plant, dg sets, transformer, etc. Genuine end users are welcome.

oil refineries & mills, Steam Valve, ball valve actuators

Oil Refinery Plant, Boiler Accessories, Boiler Accessories

Oil Refinery Plant, Pulley, Oil Refinery Machinery, Bleaching Earth

oil refineries

Gold Refinery Plant, Gold Filter Drum

fertilizer casting refineries, alloy steels, Tip Castings, stainless steels

Gold Silver Refining Plant

non edible oil refinery

Oil Refinery Plant, turnkey service, two stage watering vacuum pump

petroleum refining

Lube Oil Re Refining Plant, Medical Waste Shredder

Refineries Plant, bottling plants, Breweries Machinery