Pneumatic Tools Dealers in Mysore Road, Bangalore

Low Air Pressure & Volume Automatic Spray Gun - G05 Series Top market share in digital electrical appliances and cellular phone, digital camera, compressor and container bottle etc. Automatic Spray Gun G05 Series Recently, low pressure atomizing spray guns are apt to be used taking place of electrostatic sprayer because of high efficiency paint adhesion, good paint penetration and less paint scattering.   We have two types of "Low prussure atomizing gun" which are flat spray pattern (G05-23) and round spray pattern (G05-38). Many of our low pressure atomizing guns are adopted in the painting for cellular phone, electromagnetic wave shield material on PC, functional paint on piston, valve, turbo charger of automotive parts, fluorescent light (photocatalyst paint), super-thin paint layer of cosmetic bottle and receiving a favourable notice.   Fluorine paint, UV paint, silicon paint and molybdenum are very expensive. Therefore , it requires high efficient paint adhesion even one percent for cost reduction and less paint spattering and scattering from the point of environmental. Mesac's low pressure atomizing gun G05 series meet those market needs perfectly.   Advantages   Atomizing at low pressure and low volume   - High efficiency for paint adhesion and little loss of paint - Good paint penetration - Less spattering and scattering of paint - Preventing the stains on booth spray (Preventing the over spray)   Atomizing nozzle is made of cemented carbide and precision processed   - Excels in atomizing - Smooth paint layer can be done at low pressure   Specially shaped paint nozzle   - Preventing the paint dripping and spitting - Less stain on air cap

Jack Hammer, Drill Rods, Pneumatic Tool

AIR BLASTER SYSTEM is used as flow promoting aid in bulk solids handling. Air Blaster have proven most successful when compared with other flow promoting devices, especially in high temperature zone. Flow Problem of Bulk Solids Flow Problem of Bulk Solids are Arching, Bridging, Rat-holing & Funnelling.   FUNDAMENTAL PRINCIPLE Kaveri Air Blaster consists of an Air Vessel in which Compressed Air at 6-8 kg/cm2 pressure is stored. This full quantity of Air at this pressure is released in a fraction of second resulting in a blast, which when directed at the problematic critical zone through special nozzles, achieves the dislodging of bulk solid build-up and promotes flow   OPERATION Compressed air is fed through an air train consisting of moisture separator, filter, regulator, lubricator to the Flow Control Unit (FCU). The micro processor based sequential logic controlled (FCU) operates the individual Air Blaster in cyclic pattern. Optionally the FCU can be connected to plant PLC for blasting automation.   INSTALLATION Depending on the Equipment and location, Proper design, profile and material of Nozzle are selected. The Nozzles are mounted on the equipment so as to direct all the force of the blast to promote flow of bulk solids. In most installations, the bin / Hopper need not be emptied.. SALIENT FEATURES Spring Loaded lightweight all aluminium piston. Air Blaster mountable at any position (Horizontal / Vertical / Inclined). Air Vessel inlet and outlet at opposite ends for efficient operation and easy maintenance. Suitable for High Temperature material in excess of 1100 Deg C. 50-650 Liters capacity for wide application range.  

Portable Pneumatic Tools, High Frequency Power Tools, Portable Power Tool