Intelle Power Systems Singanallur, Coimbatore, Tamil Nadu

Surge Protection Device (SPD) is intended to Limit transient Over-Voltages and Divert Surge Current. It contails at Least one Non-Linear component Viz., Spark Gap, Gas Discharge tube (GDT), MetaL Oxide Varistor (MOV), Silicon Avalanche Diode (SAD) or Surge Diode orTranszorb.Difference between SPDs & Fuse, MCB, RFI Filter, Isolation Transformer, Stabilizers, UPS, Under Over Voltage relays

Quick Response Time High Quality Servo Motors Micro Processor Based Controller InputOutput Power Parameters in LCD Display Plug In Type PCB’s For easy maintenance. Fully Quality Tested Suitable Design for All Industries IndoorOutdoor Models Good Quality of Components. More Reliability Aesthetics Appearance. Over VoltageLow VoltageOver LoadPhase Reversal Short circuit Cut OFF Input BreakerOutput Bypass Provisions (Optional)

We are designing our K-Rated Transformers according to its guide lines and Specification given by ANSI C57 standard NFPA-70, UL 1449 and UL 1567. We use high grade CRGO laminations for our K-Rated Transformers. Our K-Rated Transformers are Class-H which will with stand 180 continuously. We use notching

Intelle is a intelligent light energy management and savings system which is compatible with lighting loads of all kinds. The system is fully microprocessor controller based operation.

Sub Switch Board distribution Panels, UPS parallel Panels, Phase Sequence Changeover Panel, Motor Control Center Panels, LT & HT Metering Panel, Outdoor Panels, UPS Input and Output Distribution panel

A power distribution unit (PDU) is a device fitted with multiple outputs designed to distribute electric power, especially to racks of computers and networking equipment located within the data center.The term (PDU) may refer to two major classes of hardware power devices; the first and typically the general unqualified term refers to the category of relatively higher-cost floor-mounted power distribution devices which transformer one or more larger capacity raw power feeds into any number of lower capacity distributed power feeds. These floor-mounted PDU devices are typically composed of transformers and circuit breakers and may optionally

Feature : K- Rated Ultra Isolation Transformer In built Compact and Aesthetics Design Individual Branch Monitoring BMS Connectivity

MV Panels, Single and Double BUS BAR Systems with ACB, MCCB and Switches with single front and Double Front Operation and Required Bus Duct and raising Mains. Our panels assured more safety and Earthing Systems as per IER Standards

An Isolation Transformer is a device which is use to decouple two circuit, the load to the Isolation Transformer and to the Input supply, Isolation Transformer suppress electrical noise which occurs in transmission line. An Isolation Transformer blocks transmission of DC signal from one circuit to other and allow ac signal to transmit. It also prevent interference cost by ground looping. Isolation Transformers are constructed with two isolated Faraday shields between the primary and secondary windings. Theuse of two shields in the construction of the isolation transformer diverts high frequency noise, which would they occur. The two shields provide more effective isolation of the primary and secondary circuits and also isolation to their grounds.

Control Panels suitable for Automotive Industries, Chemical Industries, Tea industries, Plastic Industries, Textile Industries, Paper Mills, etc.