Current Limiting and Changeover Devices Dealers in Delhi (191 products available)

• Type: Change Over Switch
• Material: New
• Application: Electrical Use
• Feature: Good Quality
• Condition: White
• Name-volkay: 32amp-300amp

32240 double pole changeover switch which contain heavy duty brass parts. Metal body & well powder coated body. Safe & secure

• Voltage: 240V
• Brand Name: Shree Shree
• Material: Sheet Metal
• Country of Origin: Made in India
• Voltage Level: Medium-Voltage
• I Deal In: New Only

We provide 16A (DP) Main Switch Box to our clients. Specification:- Super Deluxe Quality Heavy MS sheet Copper Parts

• Type: Bypass Switch
• Feature: Easy To Install, High Quality, Long Life, Low Maintenance, Low Power Consumption
• Voltage: 24 Volts Out
• Condition: New
• Power: 24 Volts Out
• Power Source: Electric

series byds bypass damper switch controls zone static by modulating motorized damper   the series byds bypass damper switch is designed to control motorized bypass dampers. As individual zone dampers open and close, the system static pressure will rise and fall. In order to maintain proper airflow and static pressure through the hvac system, a bypass system incorporating a floating type motorized damper and a static pressure control should be incorporated. A typical on/off pressure switch cannot operate in this application due to the high cycle rate that would result, eventually causing contact burnout. The byds static pressure control is equipped with a solid-state switching and timing circuit to enhance operation and improve long-term reliability in this demanding application.   control operation   the byds bypass damper switch is designed for use with a three wire floating point damper actuator used to control the static pressure on zone control systems requiring motorized bypass dampers. A bypass damper, bypasses air from the discharge air side of the hvac unit back in the return air side. The air flow is modulated in order to maintain a constant static pressure in the system as individual zone dampers open and close. The static pressure control is equipped with solid-state switching which dramatically increases the life of the control. On an increase in static pressure the byds will send 24 volts out and start the actuator to drive open. When the static pressure reaches set-point the actuator will stop. After a ten second delay the actuator will start to drive the damper closed if there has not been an increase in static pressure. A green led indicates when the damper is in the open position or being driven open. A 24 vac transformer is required to power the byds control and damper actuator. The unit includes tubing and two static pressure probes.   additional ranges can be found on the series adps/edps web page.   product applications   air filter and ventilator monitoring industrial cooling circuits fire-protection damper control ventilation duct monitoring fan heater overheating protection heat exchanger frost protection specifications   service:air and non-combustible, compatible gases. materials:diaphragm material: silicone; housing material: switch body: pa 6.6 and pom; cover: polystyrene. temperature limits:process and ambient temperature from 32 to 122 °f (0 to 50 °c). pressure limits:max. Operating pressure: 40" w.c. (10 kpa) for all pressure ranges. switch type:single-pole double-throw (spdt). electrical rating:1a @ 24 vac. electrical connections:screw terminal block. M20 x 1.5 with cable strain relief or 1/2" npt connection. process connections:5/16" (7.94 mm) outside diameter tubing, 1/4" (6.0 mm) inside diameter tubing. enclosure rating:nema 13 (ip54). mounting orientation:vertically, with pressure connections pointing downwards. mechanical working life:over 106 switching operations. weight:5.6 oz (160 g). agency approvals:ce, rohs. warranty:5 year limited warranty.   models & ordering                 model                    description   byds-06-2bypass damper switch, 2.00-10.00" w.c., m20 connection, incl installer kit  

• Country of Origin: India
• Feature: Easy To Install, Electrical Porcelain
• Tensile Strength: 0-25Mpa
• Temperature: High Temperature
• Brand Name: Soar
• Range: 63A to 1000A Four Pole, 415V, 50Hz.
• Contacts: Electrolytic Copper duly silver plated for better current carrying and heat dissipation during load.
• Usage: Where no fusing is required, only disconnection of circuit is desired.

SOAR On-Load Changeover Switches (1-0-11) Four Pole 415V, 50Hz. As per IS:13947 (Part III) IEC:60947-3

• Switch Control: Manual
• Brand Name: Bins
• Phase: Single Phase
• voltage level: Low-Voltage
• Power/Voltage: 240volt
• Color: As per standard
• Mechanical Life: Ask
• Model Name/Number: MCS-100
• Breaking Capacity: N/A

• Country of Origin: India
• Certification: ISI Certified, ISO 9001:2008 Certified
• Application: Electrical Use
• Brand Name: Boxer
• Current Rating: 16 Amp
• Rated Voltage: 240 V
• Phase: Three Phase

• Brand Name: Currentoniot
• Frequency: 60HZ
• Phase: 3 Phase
• Warranty: 1year
• Application: Industrial
• Is It Portable: Portable

We are offering change over switch. Double pole and four pole changeover switches made by ske are specially designed for modern industrial use. Application involves control power from sources. Housed in deep drawn cr sheet steel enclosure for 16 to 63 amps & fabricated for 100 to 400 amps. Sheet steel enclosures with best quality powder coating. The housing go through a rigorous anti - rust conditioning with seven tank system to ensure smooth and lasting finish against corrosive humid atmosphere. Best quality brass, phosphorus bronze components and etp copper contacts are heavily silver plated to improve the high conductivity and to protect from pollutants. Utilizing top quality porcelain.

Made using premium material, the On Load Changeover Switches, which we offer, is manufactured under the guidance of Quality Experts. We are amidst the dependable Manufacturers and Exporters of the On Load Changeover Switches from Delhi. We provide these On Load Changeover Switches at economical rates. We are known as reputed on load changeover switches manufacturers. Functions They Operate as changeover, giving three stable position (I, 0 & II) and help in Change over from one supply source to another. General Characteristic The ideal conception in Quick Cubic Change over Switches incorporate the following Advantages : Three stable position (I, O &II) and possible changeover from one to the other while functioning. Positions Circuits I and II open (Neutral Position) Circuit close and circuit II open (Transformer supply "On"and generator supply "Off") Circuit I open and circuit II close generator supply "On"and transformer supply "Off" Contact System Safely of division : Clearly apparent operation. High thermal and dynamic strength to withstand rated fused short circuit current level 80 KA rms. Is a switching control of two independent circuits (Circuit closing / CircuitII opening and vice versa). Is rated for AC23 A utilization category Design Changeover Switches are manufactured from Surdhi moulded case on load changeover switches with single handel arrangement. The switch frames are side by side for 63A-630A. The whole range is manually operated. Conformity IS 13947 - Parts 3 IEC 947 - 3, IEC 664 Auxiliary Contact : The Auxiliary contacts are of "CO" type, they provide positions signalization or pre-break control. Applications The Surdhi Quick Cubi... changeover switches are especially designed for control and disconnection of all kinds of circuits distribution feeders/motors loads. By mean of manual operation, changeover performs circuit switching and are mainly used as a switching / control of two independent circuit (Circuit closing / circuit II opening and vice versa). Attributes Compact size, Quick made & Quick Break mechanism. High electrical & mechanical life. Enclosed housing to avoid dust ingress. Load and Line reversibility." Provision of Phase separators, add-on auxiliary-switch. Door Interlock and padlock facility. Silver Plated Current carirying Parts. Bolt Holders installed on terminals for Easy Cables / Bus Part Termination. Flexibility for termination of supply. Compaq standardized size Range 63A- 630A as compared to leading indigenous makes. So, it saves panel space of cost.