Radial Drill Machine Dealers

R40 - 40mm Cap Radial Drill Machine with Fine Feed Specifications of Machine Description R40 Capacity Drilling In M.S. 40 Drilling in C.I. 45 Tapping in M.S. 25 Drilling Head Spindle Hole Taper MT-4 Spindle Travel 250 Spindle Speed (RPM x Steps) 88-2600 x 8 Diameter of RAM 78 Spindle Auto feed Range Fine Feed Working Range Max / Min Distance Spindle Nose to Base 850/250 Max / Min Distance Spindle Center to Column 920/385 Max. Drilling Radius 1005 Machine Measurement (L x B x H) 1300 x 850 x 1825 Diameter Of Column 170 Work Table 300 x 300 x 385 Power Dill-Head Motor 1.5 HP/1440 RPM Elevating Motor 0.5HP/1440 RPM Head Motor V-Belt B-46/B-47 Lifting Motor V-Belt B-23/B-24 Features : • The all new 40 mm cap. Radial drill machine is having complete oil bath lifting assembly with the shaft supported at both ends by bearings and not the bushes. • Also the heavy duty lifting screw (35mm) is supported through taper roller bearing. • It is having wide support of column (170mm with extra rib), column bracket (440mm) and arm (305mm). • Column is made of casting having long bottom for greater rigidity to reduce vibration. • The base plate is heavily ribbed below for extra rigidity. • Most important part spindle is internally and externally ground made of EN8 steel. • Spindle quill is of 78 mm dia made of steel only not the casting. • Pinion of EN8 steel and quill both are having 10 DP heavy teeth. • Greater support through wider drilling head(250mm) and closed V-Guide ways on newly designed channel type arm.

HIPAT” Precision Heavy Duty Radial Drilling Machines have a stremlined modern outlook and contain all the characteristics normally expected in a superiior qualillty machine.All the castings are of close-grained, heavy duty alloyed cast iron and amply ribbed to withstand stress without distortion, the shafts are of special quality steel andare having ground finish. all the bearings, shafts and gears of the main assemblies are force lubricated properly. the gears are induction hardened. The hardened and ground spindle run in a hardened and super-finished barrel, which slides an honed sleeve of the gear-box, the locking of the gear-box to arm and the radial movement is having special design to hold it rigidly during drilling operation.

Column, Arm, Work Head & Gears are made out of Closed Grain.Parts Properly Balanced.Prior Assembling of Main Gear & Pully.Parts Finished on imported Grinding Machine.All moving parts Finished to close Tolerance.Spindle Ram is made out of Alloy Steel.Main Spindle & Pinon are Made out of EN Forged Steel.   Features   Column, Arm, Work Head & Gears are made out of Closed Grain. Parts Properly Balanced. Prior Assembling of Main Gear & Pully. Parts Finished on imported Grinding Machine. All moving parts Finished to close Tolerance. Spindle Ram is made out of Alloy Steel. Main Spindle & Pinon are Made out of EN Forged Steel.