Wheel Sensors Dealers in Gurugram (2 products available)

Understanding vehicle behavior under real driving conditions is essential to optimizing the chassis and powertrain design. Ever-growing requirements for vehicle performance and fuel economy create many challenges for vehicle dynamics research.The Wheel force Sensor (WFS), part of A&D’s Vehicle Measurement System, can perform high-accuracy real-time measurementof forces (Fx, Fy, Fz) and moments (Mx, My, Mz) acting on the wheel hub under dynamic conditions. The WFS uses distributed force measurement and model-based decomposition in the digital signal processor (DSP) for obtainingindividual force and moment components. This method provides extremely low cross-sensitivity, interference and temperature sensitivity, while maintaining a high sampling rate. In addition to providing high accuracy and response rate, the WFS is alsocapable of compensating for tire uniformity characteristics in real time to provide the ultimate force and torque measurement.The WFS Wheel Force Sensor measures the six-component forces of a vehicle in dynamic conditions.     Highlights Six-axis force measurement- Forces (Fx, Fy, Fz)- Moments (Mx, My, Mz) High accuracy: ±0.1% High resolution: 1/4000 Light weight: 3.14 kg 10kHz sampling rate Maximum operational speed: 200km/h Rotary type transmitter and rotary encoder installed inside bearing Operating temperature range: −40°C to 100°C   Distributed Force Measurement The distributed force detection method uses four-element strain gauges. These specially-designed strain gauges are arrangedfor heat balance within an extremely small area to form a bridge circuit that eliminates the influence of heat gradients, temperature changes and cross-talk interference.

Simple mounting, For pressures up to PN10 and temperatures up to 70 °C, With frequency output, The flow transmitter can be mounted and removed from any pipe diameter (DN15 to DN400) as often as necessary, low control (fresh water, Pump protection, pump control. The paddle-wheel flow sensor is suited for the continuous flow speed measurement of neutral or slightly aggressive liquids carrying a low amount of solid matter. Flow velocities from 0.3 to 10 ms can be measured. The measuring probe provides a frequency pulse signal. Standardized fittings ensure simple insertion of the encoder into DN15 to DN400 tubes.