Power Tools Dealers in Mumbai

We are offering to our customers this range of Play Ground See Saw , that is widely installed in all playgrounds and play schools and other kids play areas. Designed keeping in mind the requirements of the safety for kids, we have made use of only good quality durable material for See Saw. Customers can avail these from us as per their requirements. We shall strive to deliver the product to them with in a stipulated time frame. We are one of the leading See Saw Suppliers and See Saw Manufacturers in Mumbai, Pune, Surat, and Maharashtra.

Hot air is suitable for soft soldering. First, you clean and degrease the point you want to solder and heat it at full power (650 deg celsius). This takes between 50 and 120 seconds depending on material, thickness and size. Once the workpiece has reached a temperature of about 300 deg celsius you offer up the solder. The solder must not be melted by the hot air itself but by the temperature of the workpiece. When soldering without flux, apply a solder cream, paste or soldering fluid to the soldering point before heating. These substances must be washed off with warm water after the soldered joints has cooled down (to prevent the risk of corrosion). Spot-soldering should be performed with reduction nozzles, pipe soldering with reflector nozzles.

Owing to our sound sourcing network, we are able to entertain bulk orders of Wall Chaser Machine from all round the country.  Featuring a strong capacity of one-step forming, our Wall Chaser provides highly competitive slotting performance. Our Wall Chaser is strongly constructed by using ultra-modern technology. This Slotting Machine can be applied to solid, cement brick and fine sand walls, but not to floors or concrete walls.

We are mfg. Of all kind of Blower high, Low pressure, Exhausters, Dust collectors, Cyclone. Blower impeller fabrication in MS & Aluminium. Welding & riveted.Drive by directly on motor shaft. C.I. coupling & vee belt.1/8 H.P. and above per requirement.  

We are offering hss circular saws. Hss ( m2 ) slitting saws are manufactured for ferrous metal and for non-ferrous metal industry. These blades are specifically suited for use in manual, semi-automatic and fully-automatic sawing operations. All blades are hardened to 6364 hrc, triple tempered and pressed quenched to give flattest saw possible. These blades are manufactured incorporating the latest developments in cutting geometries and surface treatments. these circular saws confirm to is 5031din 1837 having diameters from 20mm to 400mm and thickness range from 0.2mm to 6mm. the raw material for hss saws are rolled metal sheet, cut into blanks. The heat treatment is done by a very morden automatic, ecologically safe throughfeed hardening line. A consistent and optimal hardness of the tools is guaranteed with this new technology. Circular cutting saw blades, circular cutting knives and slitting cutters are manufactured with consistently tight tolerances on width, side-runout, diameter, and concentricity.