Intrusion Alarms Dealers in Nagpur (6 products available)

Headquartered in Maharashtra, we are well-known Exporter and Supplier of Intrusion Alarm System. The quality of our Intrusion Alarm System is tested on defined parameters at vendors’ end. We are offering a wide range of Intrusion Detention Systems at the best possible rates. We have a vast network of distributors and logistic service providers that enables us to deliver bulk orders of Intrusion Alarm System.

• Features: Simple to install, Custom-made, Industry approved designs, User Friendly, Easy to install

We provide highly acclaimed Fire Detection and Alarm System in the market. As a life safety system, the primary function of a fire detection and alarm system is for notification and evacuation of personnel. A fire detection system can add the secondary benefit of providing a much earlier warning of a fire.

• Type: Alarm
• Material: Metal
• Use: Safety
• Feature: Durable
• Finishing: Polished
• Warranty: 6 Months

Shadow Alarm detects moving shadow on LDR and starts a melodious sound alarm. This shadow alarm can be used as a simple burglar alarm that produces a loud beep when somebody crosses a protected area or door. The circuit is highly sensitive and can detect the shadow of the moving person from a distance of 1 meter. It does not require an aligned light beam to make the circuit standby. The beep generated from the circuit will be loud enough to detect the entry of a person in the room or the protected area being guarded. It is portable and can be places anywhere for monitoring.About The Circuit :The circuit uses a voltage comparator and a monostable timer to give the warning alarm on detecting a moving person. IC LM741 (IC1) is used as a voltage comparator with two potential dividers in its inverting and non-inverting inputs. Resistors R2 and R3 provide half-supply voltage of near about 4.5 volts to its inverting input (pin 2). LDR1 and preset VR1,R1 form another potential divider to provide a variable voltage input to the non-inverting input (pin 3). If VR1 is properly adjusted for the required light level, the output of IC1 will be high, which drives pnp transistor T1 out of conduction. This is due to the high potential at the base of T1. The emitter voltage of T1 will be high in this condition, which inhibits IC2 from oscillation and LED1 from lighting. IC2 is wired as a monostable timer. VR2 and C1 provide a preset time delay. As a person crosses the protected area, his shadow will be sensed by LDR1 due to change in the light intensity level and the voltage at the non-inverting input of IC1 will drop momentarily. The output of IC1 suddenly becomes low, allowing T1 to conduct. This triggers the monostable (IC2) and the alarm sounds. Adjust preset VR1 until LED1 turns off at the particular light level. Keep LDR1 facing the entrance of the room or the area to be protected. Sensitivity of the circuit depends on the proper adjustment of VR1. If VR1 is correctly adjusted, the circuit can detect a moving person from a distance of about 1-3 meters.

intrusion alarm, access controls system, Metal Detectors