Instrumentation Equipment Dealers in Shivaji Nagar, Sangli

For optimum utilization of available power the reactive power consumption should be reduced or nullified i.e. power factor should be unity, hence, most of the Power Distribution companies have policy to penalize the industrial and commercial consumers for not maintaining power factor above certain limit (generally above 0.90 value). However, due to reactive power drawn by capacitive or inductive load in the consumer premises the power factor is either lagging or leading, thus to maintain it within limit i.e. for compensating or supplying required KVAR, the capacitors (in case of lagging PF) or reactors ( in case of leading PF) are connected across the system. For stable load the fixed KVAR compensation is required , while for variable load the KVAR requirement also changes as per the load duration cycle, thus in such case the Automatic Power Factor control Panel is installedElectric Power quality is a term that has captured increasing attention in power engineering in the fresh years. The power quality is mainly depends on the needs of the equipment that is being supplied. Usually the term it refers for maintaining a sinusoidal waveform of bus voltages at rated voltage and frequency. The waveform of electric power at generation stage is purely sinusoidal and free from any distortion. All the Power conversion and ingesting equipment are also designed to function under pure sinusoidal voltage waveforms. However, lots of devices that distorted the supply waveform. These distortions may spread all over the electrical network. In fresh years, there has been an increased use of non-linear loads, which has resulted in an increased fraction of non-sinusoidal currents and voltages in Electric Network. Classification of power quality areas may be made according to the source of the problem such as converters, magnetic circuit non linearity, arc furnace or by the wave shape of the signal such as harmonics, flicker or by the radio frequency interference.     High and Low Voltage Capacitor Panel Application : For Improving Lagging Power Factor of peak loads Systems   Specification : • Multistage controller• Auto/manual controller• P.F. Closer to unity/Targeted• Thyristor/Contractor Switched• Zero voltage switching as per controller• Suitable for variable load.

We are offering ac drives. Ac drives for industrial and residential purposes in the power range from 0.25 to 22 kw. The space-saving bookshelf design with high protection classes, versatile control and programming capabilities offer an optimal solution for all operating environments. Installation, connection and commissioning procedures are extremely quick and convenient with instructions attached to the unit.

We are offering automatic power factor controller. Certain elctricals loads such as motors found in heavy machinneries ,can cause the electrical system to be highly inductive. This result in poor power factor . Poor power factor means higher energy losses which ultimately get converted into large electricity chrges. A simple solution to this problem is to balance this inductive load with equivalent capacitive load . Tis is achieved by connecting or disconnecting the capacitors to or from the system. Manual switching of these capacitors is not possible in case of rapidly fluctuating loads . So even in an environment of rapidly fluctuating loads to achieve the required power factor one may need an automatic power factor control device, called automatic power factor controller, to connect and disconnect these capacitors. Sycon 66 xx e3 controller is an automatic power factor controller used to control the power factor of the system . It can sense the powre factor of each individual phase in the three phase system and can switch the capacitors according to the requirement.

Aluminium Bus Bars, Aluminium Modular Sections, Aluminium Profile

Bus Duct Indoor Panels, High Tension Control Panel, Electrical Control Panel

Surgeon Control Panel, Video Colposcope, Binocular Loupe

Automation Products, Multi Point Indicato

Aluminium Bus Bar, Aluminium Extrusion Profiles, Sliding Window

POWER CONTROL CENTERS, Control Panels, Switch Boards, Starters, Switchgea

Electrical Panels, Conventional Type Machine, Electrical Pane

Automobile Components, Automobile Gears, Brake Drum, Clamps, Flywheel

Draw out Panel, Electrical Product, Load Break Switch, Stainless Steel Pane

Power Factor Control Panel, Control Panel, Control Panel Boar

Automobile Precision Components, Pum