Mounting Press Dealers in Ambala Cantt, Ambala

Vaiseshika’ Offers Mounting Press, the next step is mounting after Cutting the specimen. The aim of mounting is to handle small or odd shaped specimens and to protect fragile materials, thin layers or coating during preparations as well as to provide good edge retention. Mounting produces specimens with uniform size so that it is easier to handle while analyzing them.           Basically, two methods are available :       HOT MOUNTING                COLD MOUNTING In hot mounting, The specimen is mounted under heat and pressure with a hot mounting press. Cold mounting is preferred for samples which are sensitiva to damage from heat and pressure (like coatings, PCB etc.) Cold mounting resins are easy to use and require mixing which is then poured into a mould and allowed to set.

We are offering specimen mounting press. Xq-1 is manual mechanic mounting press with 3 different size of mounting mould. Temperature and heating time can be setup and shown manual on the panel.

Specimen Mounting Pres, Digital Moisture Balance, Specimen Polishing Machin

We are offering metallographic specimen mounting press.this machine is used for mounting the specimen in a bakelite powder and also to handle properly the specimen during polishing. The unit is of a rugged construction and is activated by a hydraulic press , with a pressure gauge to read the pressure being applied while mounting. The press is to be supplied complete with mould heater and thermostat with 25 mm dia mould assembly.

Specimen Mounting Press, Digital Cereal Grain Analyzer, MCT Twin Rac

Metallography Specimen Mounting Press, Floating Carriage Diameter Micromete