Microcontrollers Dealers in Chennai

High-performance, Low-power Atmel®AVR® 8-bit Microcontroller • Advanced RISC Architecture – 130 Powerful Instructions – Most Single-clock Cycle Execution – 32 × 8 General Purpose Working Registers – Fully Static Operation – Up to 16MIPS Throughput at 16MHz – On-chip 2-cycle Multiplier • High Endurance Non-volatile Memory segments – 8Kbytes of In-System Self-programmable Flash program memory – 512Bytes EEPROM – 1Kbyte Internal SRAM – WriteErase Cycles: 10,000 Flash100,000 EEPROM – Data retention: 20 years at 85°C100 years at 25°C(1) – Optional Boot Code Section with Independent Lock Bits In-System Programming by On-chip Boot Program True Read-While-Write Operation – Programming Lock for Software Security • Peripheral Features – Two 8-bit TimerCounters with Separate Prescaler, one Compare Mode – One 16-bit TimerCounter with Separate Prescaler, Compare Mode, and Capture Mode – Real Time Counter with Separate Oscillator – Three PWM Channels

Restricting to the pre-defined quality parameters, we make sure that the offered array of products is as per the stated norms. Catering to the customers' needs with excellence, we are engaged in offering high quality lot of Microcontroller.

The Arduino Uno R3 is a open source microcontroller board based on the ATmega328 chip. This Board has 14 digital inputoutput pins, 6 analog input pins, Onboard 16 MHz ceramic resonator, Port for USB connection, Onboard DC power jack, An ICSP header and a microcontroller reset button. It contains everything needed to support the microcontroller. Using the board is also very easy, simply connect it to a computer with a USB cable or power it with DC adapter or battery to get started.The Uno differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the Atmega16U2Atmega8U2 up to version R2) programmed as a USB-to-serial converter. While the Arduino UNO can be powered via the USB connection or with an external power supply, the power source is selected automatically.External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. Also leads from a battery can be inserted in the Gnd and Vin pin headers of the Power connector. The board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 5v to 12v for Arduino Uno.

ARM 2129 Development Board ARM 2148 Development Board PIC16F877A Development Board PIC16F628A Development Board PIC16F628A Development Board

Microcontrollers, Integrated Circuit, Flash Memories, Rectifier

Microcontrollers, Communication

CPLD Development Board, NXP 89V51RD2 Embedded Development Boar

We are offering Microcontroller.The peerless quality Microcontrollers offered by are used widely. They have been liked our customers for their durability and strength. They are available with us in a wide range.

Micro Controller, Machine Tools, DC Drives, Stepper Motor Driv

LPC Microcontroller, Decade Box, Logic Analyzer, Spectrum Analyze

Micro Controller, Uninterrupted Power Supply, Voltage Stabilizer

Micro Controllers, Diodes, Electronic Components, IGBT Module

Microcontrollers, Electronic Controlle

Industrial Microcontroller, Power Saving Micro Processor Controller

Microcontroller Development Board, Laboratory Products, Workshop Equipmen