Industrial Paint Dealers in Vasant Kunj, Delhi

UV coating cures and is chemically crosslinked. This provides for a coating film which has much higher chemical resistance than the waterborne. For example: you can actually wipe our cured coating many times with either Acetone or MEK (both very strong solvents) and the result will be that you will clean the coating but see absolutely no change in the gloss or corrosion resistance of the coating. If you try this with waterborne or solvent based coatings you will remove or severely degredate the film to the point where you have no corrosion resistance at all. UV coating is 100% solids. This allows for more exacting film thickness application and control. Everything which is applied to the tube stays on the tube at whatever film thickness you desire. The waterborne and sovent based coatings can be low solids which means in order to apply a desire film thickness, you must apply many times your desired film thickness and then force the volatiles out of the coating to come back down to an approximate film thickness.

We are an recognized manufacturer and supplier of an exclusive range Epoxy PaintsWe are an recognized manufacturer and supplier of an exclusive range Epoxy Paints

We manufacture and supply premium Fire Retardant Anti Bacterial Paint for interior and exterior applications. The Fire Retardant Anti Bacterial Paint that we supply offers anti bacterial feature and acts as an additional supplement for effective cleaning and reducing the risk of growth, spread of fungus and bacterial throughout the building. Fire Retardant Anti Bacterial Paint is widely used in hospital labs, school, food industry, washroom, lobbies etc. Cobra Brand Weathertouch – Wall finish premium quality plastic paint for interior & Exterior   Anti bacterial paint finish acts as an additional supplement to effective cleaning & reducing the risk of the growth and spread of bacteria throughout a building.   It is widely used in Hospitals, labs, schools, food industry, airports, offices, government buildings, washrooms, lobbies, and houses etc. Application Procedure Step 1 : Surface Preparation : Freshly plastered surface need no special preparation however, old surface are to be cleaned for flaking, chalking and loose plaster.       Step 2 : Sealer Coat : On old surfaces, where the plaster is weak and loose, a suitable sealer coat should be applied after priming and crack filling. Step 3 : Prime to apply cement primer coat before final application.      Step 4 : Maerial application – 2 coats Important  : For a large surface area, material of same batch is recommended  Preserve the material in a cool, dry place, long exposure to direct sunlight may change the form and condition of the material The primer & undercoat should be left overnight before application of the top coat. ] Do not apply the material in adverse climatic conditions like rain, strong wind etc. As it would affect the application. Application should be done above 25 deg. C., and on completely dry surface.

Teflon Coating, Engine Tune up, Anti Rust Coating, Car Was

Car Paints, Fancy Ladies Kurt