Crack Meter Dealers (8 products available)

• Model Name/Number: Crack Depth Meter 281M
• Material: Stainless Steel
• Measuring Range: 0.2 to 100.0 mm
• Frequency: 50-60 Hz
• Dimension: 160X85X30 mm
• Usage/Application: Industrial
• Brand Name: Pro

• Material: Stainless Steel
• Color: Metallic
• Feature: Durable
• Use: Industrial
• Finishing: Polished
• Warranty: 6 Months

Model SIS -120 Crackmeter are used to measure movements across surface cracks or joints in structures, concrete or rock. The Crackmeter incorporates vibrating wire sensor with the resonant frequency of vibration of a tensioned steel wire is proportional to the strain or tension in the wire. This fundamental relationship is utilized in a variety of configurations for the measurement of load. The design contributes to the outstanding features and performances over conventional Vibrating Wire Crackmeter.   The Model SIS -120 Vibrating Wire Crackmeter offers: Unprecedented sensitivity Long term stability and reliability Isolation of the sensor from the effects of total stresses acting on the body of the Jointmeter/Crack meter Robust and sturdy construction Slim-line design Features : Accurate, highly sensitive and reliable In-built thermistor and gas discharge tube Extremely stable for long term operations Frequency output for transmission over long distances Suitable for remote reading, scanning and data logging Stainless steel construction Typical Application : The Crack meter is designed to measure: Lifts in Dams Fault movement in rock Strata deformation Crack separations Separation of Shot Crete Description : Series SIS-120 offers the following: Crackmeter SIS 120A - designed to measure movement in surface crack and joints Displacement Transducer SIS 121 – designed for measuring linear displacement in Borehole Extensometer Socket Assembly - facilitate assembly of Joint meter in concrete/masonry Dams. Mounting Brackets - facilitate the use of joint Meter for crack measurement Operation :The Crackmeter transducer employs a shaft coupled by a spring, which is attached to heat treated high tensile strength steel wire. Movement of the shaft changes the tension in the spring and in the wire causing a corresponding change in its frequency of vibration. The wire is plucked by energizing the coil magnet so that it vibrates at its natural resonant frequency. The resonant frequency is proportional to the square root of the tension of the wire. A conventional readout unit can accurately measure the frequency of the wire. A microprocessor based readout unit can display the frequency as well as the value of the measured pressure directly in engineering units.   The Crackmeter are suitable for connection to data loggers for recording data in engineering units automatically at pre determined intervals. By the use of appropriate software, the data logger can present recorded data in desired formats, predict trends of variations and even generate alarms at pre-determined set points. The thermistor mounted in the Jointmeter and crack meter enables simultaneous measurement of temperature. This allows any corrections to be made in the observed readings due to temperature changes. Crackmeter with lightning protection is available on request.Specification : Standard Ranges 50, 100, mm Resolution 0.10% F.S. Accuracy ±0.250% F.S. Nonlinearity <0.2% F.S. Temperature Range −20°C to +80°C Body Diameter 16 mm; Shaft 6.35 mm Overall length in close position Lengths 320, 340, 380, 550 mm (transducer)