Power Controllers Dealers

We offer SYCON-55 XX - Automatic Power Factor Controller. This 55 series version uses microcontroller technology but with necessary and sufficient features. The main feature is two point setting to avoid hunting at site by user convenience which eliminates calculations and setting of CK. The switching sequence is in "First In First Out" i.e. FIFO manner. It is very easy to install and its bright 4-digit 7-segment display makes it readable from dis

Certain electrical loads such as motors can cause electrical systems to be very inductive, which results in very 'lagging power factor' i.e. wastage of energy. The simple solution to maintain the power factor in required range is to connect or disconnect the power factor correction capacitors. Manual switching is just impossible for rapidly fluctuating loads and hence an automatic control system is required which continuously monitors the power factor and make appropriate corrections to maintain it within the required range Power Factor Controller Range With a very wide spectrum of features and prices, we have a wide range of automatic power factor controllers. This includes very high range models such as SYCON 66SS with a Smart Switching Algorithm implemented for fast power factor achievement as well as low cost models based on most common FIFO switching algorithm.

Features RISC Microcontroller based field proven design Three digit PF display Individual Stage LED indications Indication range from 0.5 lag to 0.5 lead User settable High and Low set points also in three digit User settable bank on time, bank off time, bank discharge time Settable Cyclic or FIFO switching sequence Settable No Load Compensation (NLC) For Transformer Auto or Manual Mode Selectable from outside switch For all settings the controller is protected by a password to avoid unauthorized access. Test mode for testing the wiring logic when there is no load current. Input voltage from phases R & Y Input Current from phase B CT All Electrical Connections on rear side Potential free relay contact outputs to operate the banks Relay contact rating is 5 amps at 230 VAC