Jumper Wire Dealers

These cables are used as supplementary cable to connect kickless cable and gun are of the single conductor only. To meet the connector needs in the resistance welding operation. Electromech offer a broad variety of secondary cable. Each cable is design and built to perform with maximum efficiency and economy in its in depended application. Electromech water-cooled jumper (Aid)cable to electrically connect distant points which move in relation to each other such as, The movable gun-arm of the certain types of welding guns to the electromech cable. On a multiple spot welding machines. Electromech water cooled jumper & sub cables are flexible rope types secondary connectors, assembling with high conductivity terminals. There are sheathed with reinforced abrasion & oil resistant hose. Free water passage is insured by means of an open spring core progressing the entire length of the cable. Thus permitting the cable to operate under the condition of acute bending without obstructing the water flow. TERMINALS Straight lugs are machined from high conductivity   electrolytic  Copper bar stock. Bends lugs are forged and machine from high conductivity electrolytic copper.   WIRE CONSTRUCTION This is a made from 0.05mm2  electrolytic grade Copper wire. Each bunch or herringbone construction to reduce the rate of wire facture by providing lateral surfaces wears areas. The total sectional area shall not be less than the sectional area as per MCM/mm2 rating.   Wire connection to terminal Water is terminated in a crimped in   soft electrolytic tube and the soldered to the terminals. Wire cannot melt out during brief overloads   FLEXIBLE HOSE COVER The outer rubber hose made of heat resistant on its inner Surfaces & abrasion resident on its outer surfaces.   WATER FLOW Coiling water is passed at the rate of 3 lit/ min at the pressure of the 6kgf/ cm2 and the pressure drop does not exceed 0.7kg/ cm2   WATER PRESSURE The cable is tested at a pressure of 6 kgf/ cm2 (kcs) to ensure then there is no leakage or hose damage.   Optional feature ROTECTION SLEEVES: - In order to eliminate breakage of strands due to frequent acute bending operation, projection sleeves are provided on the area of both the terminal joints. 

To meet the connector needs in resistance welding electromech offers a broad variety of secondary connector. Each cable, secondary shunts are designed and built to perform with maximum efficiency & economy in its intended application. Electromech air cooled jumpers cables are required to be electrically connecting distant points which move in relation to each other. Such asThe movable gun–arm of certain types of welding guns to ASMITA ENGINEERING cable.On multiple spot welding machines   ASMITA ENGINEERING air cooled jumpers are extra more flexible rope type secondary conductors with connector, swage- formed on each end for maximum flexibility & cooling. The standard terminal width is 32 mm. if wide terminal is required, please specify when ordering. TerminalsTerminals are made for soft electrolytic copper tube.Wire construction : - This made from 0.05 mm2 electrolytic grade copper wire each bunch of herringbone construction to reduce that the rate of wire fracture by providing the lateral surface wear areas. It is a total sectional area shall not be less than the appropriate sectional area per MCM/mm2 rating Wire connection to Terminals : - Wires are brazed crimped in the soft electrolytic copper Tube. Wire can not melt out during brief overheads. Flexible cover : - A loosely fitting rubber impregnated sheath encases most Cable styles for mechanical protection. Optional Feature :-Protection sleeves: - In order to eliminate breakage of strands due to the frequent acute bending operation, protection sleeves are, provided on the area of both the terminals joints.

Jumper Cables, RF Cables, Fiber Optic Cables, PCM Cables, e3 Cable