Dryers Dealers in Meerut (14 products available)

• Material: Stainless Steel
• Weight: 50 Ton
• Voltage: 350 V
• Power: 120 Kw
• Warranty: 1 Year
• Drying Temperature: 350±30℃

Advantages Energy consumption is much less than spray dryers, fluidized bed dryers, flash dryers, rotary dries, tray driers etc. Space requirement for installing this dryer is much less than spray dryer, pneumatic dryer, fluidized bed dryer and rotary dryer etc. It is a completely automatic plant with temperature controller etc. Dry product discharge section of the dryer can be installed in your product packing section, hence cost of transport of dry product to the finished product section can be eliminated. Pulverizing after drying will not be required. The unit will dry, classify and convey all in a single operation. Wet cake can be directly fed from filter/centrifuge to lump breaker bin, which feeds the cake in to the dryer and hence all intermediate handling of material can be eliminated. The entire system is closed and hence any chance of contamination is eliminated. Since it is a closed system, wastage and dusting etc. are totally eliminated resulting in clean environment, zero wastage and total recovery of product and pollution free atmosphere. It is possible to vary the bulk densities also by minor changes in the classifier situated near the top of the dryer. Feature High drying efficiency and low energy costs. The energy efficiency of such systems is up to eight percent, which is very high for such types of drying systems. Direct drying and no initial diluting. Continuous processing with short drying time. Ideal for replacing conventional drying systems such as Fluid Bed Dryers, Pneumatic Flash Dryers etc. Pulverizing, conveying, classifying etc. can be done on the same system. Space utilization is most economical and operations are totally automatic. Most of the time, the product can be directly bagged or sent for further processing. Self-regulating, self-adjusting system, which involves minimal attention even while operating at capacity. The system being under negative pressure, there is no dusting and therefore no wastage. The area is free from environmental hazards. Clean operation with minimal manual handling is an important feature of the system. Application Direct contact dryers for bulk drying of various products such as inorganic chemicals, bulk drugs, dyestuffs, insecticides foodstuffs etc. Chemical industry products like Zinc Carbonates, Calcium Carbonate, Magnesium Carbonate, Cobalt Carbonate, Zirconium, Red Ferric Oxide, Aluminum Hydroxide, Lead Sulphate, Zinc Sulphate, Fire retardant Super - fine Calcium Carbonate, Zinc Oxide, Barium Sulphate, kaolin, Pigment, Dyestuff, Pesticide, Mancozeb etc.

Procured from well-known vendors, our Air Dryer is accredited for various features such as remarkable performance, longer service life, high corrosion resistance and low maintenance cost. In order to meet the urgent & bulk orders of buyers, we maintain a huge stock of these products in our state-of-the-art warehouse. Besides, when it comes to delivery, we assure all the orders are delivered within the allocated time period.   Features : Operating on ADSORP principle; Hence prevents entrainment of moisture in the pipe line however long is may be The most compact skid mounted unit supplied in READY FOR USE state by connecting compressed air at inlet and outlet The stationary working system and requires negligible maintenance Assured atmospheric dew point equal to (-) 40 deg. C. or (-) 70 deg C as required Ideal purging as per desiccant manufacturers instruction for regeneration Lesser pressure drop in total unit Modified purge silencer causing less noise Designed for Indian atmospheric condition Easy for installation and commissioning

• Country of Origin: India
• Type: Hair Dryer
• Material: HDPE, LDPE, Plastic, PP, PVC
• Certification: CE Certified, ISI Certified
• Application: Parlour, Personal
• Weight: 100-200gm, 200-300gm, 400-500gm, 500-600gm, 600-700gm, 700-800gm, 800-900gm, 900-1000gm
• Color: Black, Blue, Brown, Green, Grey, Orange, Red, White
• Feature: Attractive Designs, Auto Heat Resistant, Energy Saving Certified, Hanging Loop, High Air Flow, Light Weight, Low Power Consumption, Quick Dry, Stable Performance
• Voltage: 220V
• Automatic Grade: Automatic, Semi Automatic
• Power: Battery, Electric
• Power Source: Battery, Electric
• Warranty: 1year
• Frequnecy: 50HZ
• Brand Name: China

Spray drying is the transformation of feed from a fluid state into a dried form by spraying the feed into a hot drying medium. The feed is pumped from the product feed tank to the atomizing device, located in the air disperser at the top of the drying chamber. The drying air is drawn from the atmosphere via a filter by a supply fan and is passed through the air heater to the air disperser. The atomized droplets meet the hot air and the evaporation takes place, while cooling of the air happen simultaneously. In Spray Drier, after the spray is dried in the drying chamber, the majority of the dried product falls to the bottom of the chamber and enters to a pneumatic conveying and cooling system.The fines, which are the particles with a small diameter, will remain in the air, and it is therefore necessary to pass the air through cyclones to separate the fines. The fines leave the cyclone at the bottom via a locking device and enter the pneumatic system, too. The air passes from the cyclone to the atmosphere via the exhaust fan. The two fractions of powder are collected in the pneumatic system for conveying and cooling and are passed through a cyclone for separation, after which they are bagged off. The instrumentation comprises indication of the temperature of the inlet and outlet air, as well as automatic control of the inlet temperature by altering the steam pressure, amount of oil or gas to the air heater, and automatic control of the outlet temperature by altering the amount of feed pumped to the atomizing device.  There are two basic types of atomization : Nozzle atomizer Disc atomizer Spray Drier Configuration : Co-Current Flow Counter Current Flow Advantages Of Using A Spray Dryer For Drying Application : Control of particle size. Spray dryers can typically produce between 30 to 500 micron average particle sizes, in a bell shaped distribution. The shape of most spray dried particles is spherical, which provides for fluid-like flow properties. Spray drying produces the most homogeneous product. Many heat sensitive products can be spray dried easily at relatively high inlet temperatures. Permits drying without thermal degradation.

• Weight: 11.5 kg
• Voltage (Volt): 220 , 240

The company has firmly positioned itself as one of the most promising hair dryer importing, exporting, and supplying units in india. Hair dryers available with us are specially designed keeping in mind the harsh effects of moisture on hair. These hair dryers are safe to use and does not damage the quality of hair. In addition to this, hair dryers from the house of akshay enterprises is famous among beauty parlors, best quality etc

Our Technical Expertise Enables Us To Manufacture And Supply A High Quality Teflon Tape Drier Machine. The Offered Teflon Tape Drier Machine Is Manufactured Using High Quality Raw Material And Precise Engineering Techniques To Meet The Set Industry Standards. This Teflon Tape Drier Machine Is Inspected By Our Quality Controllers To Ensure Extended Durability. Further, We Offer This Teflon Tape Drier Machine In Various Technical Specifications At Market Leading Price. Features : Robust Construction Precise Dimension High Performance

•  :  
•  :  
• Capacity: 2, 3, 4, 5 Liter (and Above).
•  : Temperature Range
• -55 & -86.:  
• Defrosting: Auto/Manual.
•  : Model
• Table Top / Floor.:  
• Controller: Microprocessor Based Digital Controller.
•  : Tray System
• As per Requirement (3 or 6 Tray).:  
• Flask Arrangement: As per Requirement.
•  : Vacuum Pump
• Yes.rds. 400:  
•  :  

• Specialities: High thermal efficiency,Low operating costs,Low maintenance costs
• Voltage: 220-380V
• Material: MS

• Features: Precise construction, Optimum performance, Elevated service life.

• Max Temperature: 200 degree Celsius
• Power Source: Electric
• Material: MS, SS
• Automatic Grade: Automatic
• Design: Standard
• Application: Industries

Lipstick Box, Face pri, plastic kajal pencil, edge trimmer

Dryers, brass divisional strip, Brass Strips, Industrial Nozzles

Hand Dryers, house keeping material, Soap Dispenser, Floor Mats