Heating Components & Spares Dealers in Andheri West, Mumbai

Inventum Induction Heater Model HIR-2540 is specially designed to dismount and mount the Inner Races of Cylindrical Roller Bearings used on the Axles of Railway Rolling Stock and in Traction Motors. The equipment can also be used for similar applications by other industries.When a job is heated with the induction coil it acquired magnetism strong enough to attract iron particles, iron dust etc. To deal with this phenomenon, it is necessary to eliminate the residual magnetism after heating. The design of Inventum Induction Heater Models HIR-2540 permits fast demagnetisation by use of the heating coil itself. The Induction Coil can be used for demagnetisation as well as heating.

TECHNICAL SPECIFICATION i - Type – Vertical/Horizontal, 3 pass, Coil Type Thermic Fluid Heater ii - Capacity – 50000 kcal/hr to 2500000 kcal/hr and above iii - Temperature - Up to 300°C and above iv - Fuel - Gas / Diesel/Heavy Oil/ Dual Fuel v - Thermal Efficiency - 88% + 1% based on N.C.V. of Fuels vi - Heat Recovery Unit – Economiser (Optional) vi - Air Preheater - In-built     OPERATION i - Fully automatic operation with BURNER ON-OFF modulation for units up to 40 Lac kcal/hr and HIGH-LOW ON-OFF modulation for higher capacity units keeping FUEL CONSUMPTION in proportion with heat demand in the plant ii - The Burner is pressure atomizing type and is centrally located at the top of the unit iii - Burner is self igniting and maintains CLEAN and SMOKELESS COMBUSTION all throughout the operation iv - Preheated combustion Air gives highest Combustion efficiency maintaining high CO2 % and Low Smoke Index v - Hot Oil circulation pump is of centrifugal type maintaining the circulation of Hot Thermic Fluid through heating coil vi - A Digital Temperature Controller senses the heat demand in the plant and controls the Burner ON-OFF/HIGH-LOW modulation maintaining minimum fuel consumption vii - In case of any abnormal operating condition the SAFETIES provided stop the unit and put the same to SAFETY LOCKOUT CONDITION by giving AUDIBLE ALARM and VISUAL INDICATION     SAFETY FEATURES i - Flame failure device ii - Thermic Fluid low flow tripping iii - Overriding temperature tripping iv - Blow down valve v - Single phasing prevention cum over load for control circuit vi - Miniature Circuit Breaker for control circuit vii - Thermic Fluid level switch on expansion tank (optional) viii - High stack temperature Annunciation/Alarm (optional) ix - Fail Safe Instrumentation x - Control circuit logic ensures Heater going to lock out safety in case of any abnormality in operating condition as well as monitoring instrument failure

We are manufacture wide range of certified flame proof heaters and safety air heaters for use in hazardous environments. Flame proof heaters provide the best solution for safe heating in Zone 1 and Zone 2 areas exposed to explosion hazards. A range of models are available that suits your requirement. Flame proof heaters is used in various industries like food and beverage industries and other corrosive atmospheres dissipation area are extremely efficient for raising air temperature. The heaters are metal sheathed and are completely insulated. The unit is provided with wire guards on both sides. A well designed blowing arrangement maintains proper air circulation over the heaters with requisite pressure.

Induction Heating Equipment, Induction Heater, Bearing Heate