Soil Testing Equipment Dealers in Roorkee

Specification:-It is used for the determination of the consistency of freshly mixed concrete, where the maximum size of the aggregate does not exceed 38mm.The slump cone has internal dia of 20cm at base and 10cm dia at top and 30cm height.

The double ring Infiltrometer is a simple instrument which is used to determine the infiltration rate of water into the soil. The infiltration rate is determinate as the amount of water per surface area and time unit, which penetrates the soils. This rate can be calculated on the basis of the measurements and the DARCY's law. Several measurements can be executed simultaneously, yielding a very reliable and accurate mean result. As vertically infiltrated water runs away to the side. The outer ring of the Infiltrometer serves as a separation. The measurement exclusively takes place in the inner ring through which the water runs virtually vertically. The instrument consists of two rings, driving plate, for inner and outer rings. The two rings are driven into the ground and partially filled with water. The double ring design helps prevent divergent flow in layered soils. The outer ring acts as a barrier to encourage only vertical flow from the inner ring. The standard set of the double ring Infiltrometer consist of 2 steel rings with different diameters, a hammer, floats, a stainless steel hammering cross and a stopwatch.

We are a nonpareil Manufacturer and Supplier of Reynold Apparatus. The Reynold Apparatus offered by us is used to visualize different flow conditions i.e. laminar flow, transition flow, turbulent flow, etc. Our Apparatus is also used to find out the Reynolds number. The complete range of the Apparatus is reasonably priced by us.   Details : The apparatus is used to visualize different flow conditions i.e. Laminar flow, transition flow, turbulent flow, To find out the reynolds number the apparatus consists of : A centrifugal pump of 25mm x 25mm with 14 hp motor (isi make) M.S sump tank 80 ltr. To collect the water. M.S measuring tank 40 ltr fitted with piezometer tube to measure the discharge. Damper is used to collect the water in m.s. Measuring tank for certain time. G.I pipe of internal dia 25.4mm (1") and g.m. Isi mark control value and regulating valves are used to circulate water. Bye-Pass line is also used to regulate the discharge. This apparatus consists of a perspex tube of internal dia 25mm dia x 100cm long. A needle and color dye injector tank is used to visualize the flow. The tanks are well epoxy painted insided to prevent rust hence increase the life of tank.   Experimental capability : To visualize different flow conditions. To obtain the critical velocity

the three hinged arch apparatus manufactured, exported, imported and supplied by our company, consists of a curved beam mounted on two fixed supports and usually featuring the so-called crown hinge at its crown. The hinges on the two fixed supports absorb vertical and horizontal forces, and are known as abutment hinges. Their connecting line is the springing line. The crown hinge renders the system statically determinate.

Unconfined Compression Test Apparatus many a time it is essential to know unconfined compressive strength of soils saturated or nearly saturated.These results give an idea of the bearing capacities. Unconfined samples are unidirectional loaded gradually till failure in the test.

We offer Sand Pouring Cylinder. Sand Pouring Cylinder (Small) The apparatus is suitable for field density estimation of fine and medium grained soils, as per IS: 2720 (Part XXVIII). It consists of: i) Sand Pouring Cylinder 115 mm internal dia with conical funnel and shutter. Ii) Calibrating Container,100mminner dia and 150 mm deep with flange 50 mm wide. Iii) Metal tray 300mm square x 40mm deep with a 100mm dia hole at the centre. (Large) The apparatus is suitable for estimation of field density of fine, medium and coarsegrained soils, as per IS : 2720 (part XXVIII). It consists of :- i) Sand Pouring Cylinder, 215 mm internal dia, with conical funnel and shutter. Ii) Calibrating container 200 mm inner dia x 250 mm high with 75 mm wide flange. Iii) Metal tray 450mmsquare x 50mmdeep with a 200 mm dia hole at the centre

Sampling Augers is in two sort and each in various sizes.Each twist drill equip comprises one each of Auger head, one meter long pole, Tee piece and hangle.

Soil Testing Equipment, Geographical Instrument, Scientific Instrumen

Triaxial Cells, Sugarloaf Great Helmets, Chain Mails, Roman Medieval Helmet

Soil Testing Equipment, Surveying Instruments, Auto Level Instrumen

Soil Testing Equipment, Soil Testing Service

Bitumen Testing Equipment, Bumpers, Electronic Equipmen

Soil Testing Equipmen

We are a prominent Cone Penetrometer Manufacturer and Supplier in Roorkee. The Cone Penetrometer, we bring forth, is an automatic machine which enables the determination of liquid limit to the performed simply and quickly. The Cone Penetrometer, which we provide, is used in Soil Testing Departments for different purposes. The Cone Penetrometer provided by us is made in compliance with the industrial quality standards. About Cone Penetrometer : The unit is supplied complete with a stainless steel penetration test cone 35mm long with a smooth polished surface and an angle of 30 degree operation 20 volts, single phase A.C. SupplyUsed for determination Liquid limit of soil as I.S. 2720 Part V supplied complete with one penetration cup 50 mm internal dia X 50 mm high

Soil Testing Equipment, Surveying Equipment, Meteorological Equipmen