Testing Equipment Dealers in Bannerghatta Road, Bangalore (24 products available)

In-Circuit Tester (ICT), is a powerpacked technologically advanced tool for printed circuit board testing. Using a ‘bed of nails’ in-circuit test equipment it is possible to gain access to the circuit nodes on a board and measure the performance of the components regardless of the other components connected to them. 

• Features: Optimum strength, Robustness, Rough and tough to use

Functional Tester for INCOM System of LCA, Su30 & Jaguar On board RF Signal Generator , RF Signal Analyser, Audio Signal Analyser / Signal Generator, Modular Measuring instruments, RF switch Frequency Range : 100MHz – 500 MHz Parameters tested - Frequency Error, Carrier Power, Power Consumption, Modulation Depth, Modulation Distortion, Incidental AM/FM, Side tone Output, Side tone Distortion, Modulation Response, Side tone Response, CNR, Harmonic/Spurious Rejection etc   RF Hardware Capability - Generator / Analyzer RF Frequency range - 108MHz to 399.975MHz RF Amplitude - -120dBm to +10dBm Input / Output impedance - 50ohm. Real time bandwidth - 20MHz No of RF channel (Input) - 1 No of RF channel (output) - 1 Audio Frequency range - 300Hz to 3KHz Audio Signal Amplitude - 250mV to 500mV (rms) No of Audio channel (Input) - 2 No of Audio channel (output)- 2 Modes Supported - Auto & Manual Communication Protocol - MIL-STD-1553B UUT Test Capability - 1210A (MBU), 1210AL,(LCA), 1215A (SU 30)

Data acquisition (DAQ) is the process of measuring an electrical or physical phenomenon such as voltage, current, temperature, pressure, or sound with a computer. A DAQ system consists of sensors, DAQ measurement hardware, and a computer with programmable software. Low, Medium and high channel count is available with 12 bit 32bit resolution. Dedicated measurements for temperature, strain, force, pressure, voltage and current DAQ systems are available

Features :   Interior and Exterior both made of Stainless Steel. 3 Different model sizes: 108, 256 & 749 litres. Temperature range: +10 °C up to +60 °C (with humidity). Temperature range: -10 °C up to +60 °C (without humidity). Models with light simulation & CO2 control also available for above sizes. 1 model variant - : TwinDISPLAY. Double door as standard, Air jacket thermostating system. Capacitive type humidity sensor. Large illumination area with outstanding light homogeneity (model ICH L). Validatable software according to FDA 21 CFT Part 11 available as option. Various accessories available as option on request.

The practical digital display and LED system provide instant viewing of the required information with high quality precision and efficient battery control. Moreover, the possibility to select the reference standard used by the battery manufacturers (EN,IEC,DIN,SAE,CA-MCA), each of which refers to the different ranges of start currents, is further confirmation of the exceptional versatility of this instrument. It is powered by 4 x 1.5V AA batteries and can print out the measure report.

Perfect first meter! • 19 Range • 3.5 Digit • Transistor Test • Diode Test • 10A DC Current • Ideal First Meter • Compact Size • CAT II 500V This is a full featured meter with plug-in 4mm probes AND transistor tester. This is the ideal first multimeter, and will give years of faithful service, in fact, you will only need to replace this meter if you require a unit with very high input impedance Specifications: • DC Voltage: 200mV, 2000mV, 20V, 200V, 1000V • Max Input: 1000V DC -/+0.5 • DC Amps: 200uA, 2000uA, 20mA, 200mA, 10A • Overload Protected • AC Volts: 200V, 750V, max input 750V rms input • Impedance 1Meg +/-1.2% • Resistance: 200, 2k, 20k, 200kohms, 2Mohms +/- 1.2% • Size: 125(H) x 68(W) x 23(D) mm

digital static multifunction meter, Voltage Vacuum Contactor

Leak test apparatus made out off ss 304 Quality argon arc welded comprising a Cylindrical vessel and ss lid provided with Gasket and ss wing nuts for locking. A glass window provided at the top enables easy Viewing inside. A vacuum gauge with two control valves one For charging and one for releasing vacuum Vacuum pump for the above is required.

• Features: Automatic testing, with pre selected cycle without a remote control operation

A complete suspension diagnosis system consist of Roller Brake Tester, Suspension Tester and Side Slip Tester. Developed to grant modularity and user friendlyness, it incorporates latest generation equipments in conformity with applicable safety regulations.

• Type: Dc Watt Hour Meter
• Weight: 100-200gm, 200-300gm, 300-400gm, 400-500g
• Color: Brown, Green, Grey, Red, White
• Display Type: Digital
• Automatic Grade: Automatic, Fully Automatic, Semi Automatic
• Body Material: Aluminum, Brass, Cast Iron, Copper, Plastic, Stainless Steel
• Power Source: Electric
• Feature: Accuracy, Durable, Light Weight, Lorawan Compatible, Multi Jet, Stable Performance
• Warranty: 1Year

• Type: Digital
• Frequency: 50/60Hz
• Voltage: 480V ac L-L
• Brand: Schneider
• Usage/Application: Industrial
• Display: Elegant single row, backlit LCD display
• Power accuracy: 0.50%

• Features: Dimensionally accurate , Perfectly designed , Easy installation.

• Features: Less maintenance, Highly acclaimed, Safe use

We are supplier and exporter of this product.

RFID Wireless Monitoring Systems, Dvr Cards, Miniprox Access Control

battery discharger, variac, static stabilizer, Inverters

Testing Equipment, dilator, endoscopic forceps, gynecology products

PVC, acrylic buttons, 20ltrs jar closure, water can tops, bottle closures

Oscilloscopes, Power Supplies, engineering lab equipments

plastic electrical meter, injection moulding components

vehicle emission testing equipment, Emission Testing

Elmeasure, Siemens AC Motors, Omron, unistar cables, Hindustan Motors

Re-defining LS-1881 Multiple Air Leak Tester, Hydorogen Leak Detector