Electronic Test Instruments Dealers in Mohali

• Measure Vrms, lrms, W, PF; • Voltage range:10-600v,Current range:0.005-20A ; • Accuracy: ±(0.4%reading + 0.1%range + 1digit); • Can communicate with computer through RS-232 interface.

Backed by the sound infrastructural facility and experienced personnel, our company has been able to emerge as one of the renowned manufacturers and exporters of tester for automobile battery. Widely used in automobile industry, these are manufactured as per requisite norms and standards. In order to accomplish the varied requirements of our patrons, these testers are available in various specifications. Our range of tester for automobile battery is known for its high efficiency, compact design and low maintenance features.

This needle type magnetic field indicator is used to measure residual magnetic field in components after magnetical particle testing. They are available in two ranges: + – 10 Gauss + – 20 Gauss

Battery testing as per IS 1651 The scope of this standard specifies the rated Ah capacities, overall dimensions, performance requirements and test of stationary Lead acid cells and batteries using tubular positive plates. The following type tests are carried out in given sequence: Verification of constructional requirements (Clause 12.2) Cell lids, venting device, Electrolyte level indicator, and terminal posts, connectors, and nuts and bolts spray arrestor are verified for their constructional requirements. The cells shall meet the entire requirement according to the Clause 6 of IS 1651. Verification of marking (clause 12.3): The following information must be durably marked on outside the cell. Source of manufacturer, Ah capacity at 10- hours’ rate, Upper and lower electrolyte level for transport containers, year of manufacturer, country of origin and the standard mark. The cell shall be suitably packed to avoid any loss and damage during transit. Verification of Dimensions( clause 12.4): The ampere hour capacities and dimensions of the cells shall be in accordance with the table below: ITC can do Electrical Safety testing against Battery Testing for following types of productsstandards: As per IS 1651 As per IEC: 60896-11 a. Verification of Constructional Requirement a. Capacity test b. Marking & Packing b. Charge retention Test c. Verification of Dimension c. endurance in discharge-Charge Cycle d. Ah and Watt Hr Efficiency test d. endurance in over charge e. Test for suitability for floating battery operation f. Short Circuit and internal resistance test

We offer for online ph meter for effluent treatment plant & sewage treatment plant kindly contact us.

Digital Water Meter, Chipboard Screw, Brass Water Meter, Woltman Water Mete

Data Acquisition Recorder, Water Heater Elements, Thermocoupl

PH Meter, Imported Embedding Cassettes, Ovens, Electrophoresis Apparatu

Energy Meter, Electronic Equipmen

Conductivity Sensor, Fermenter Vessel, Dissolved Oxygen Monitoring Syste

PH Meter, Digital Incubator Controller, Electronic Instrument

Single Phase Meter, Energy Meter, Surge Protection Device, Solar DCD

Air Conditioning Ultrasonic BTU Meter, Heat Meter, Air Fuel Ratio Controlle