Testing Equipment Dealers in Shastri Nagar, Ghaziabad

(12 products available)
  • Bursting Strength Tester

    Bursting Strength Tester

    Get Price Quote

    • Test FluidGlycerin
    • Rate of fluid displacement95 cc / Minute
    • Motor¼ HP Geared Motor
    • Power220 Volt AC 50 Hz.
    • Maximum Capacity35 Kg/cm2.
    • Capacity of Test Fluid tank160 ml
    • Opening of upper clamp31.5 mm
    • Opening of lower clamp30.5 mm
    ...more
  • Insulation Tester

    Insulation Tester

    Get Price Quote

    Insulation failure is one of the most common causes of electrical break-down. Regular testing however will reveal insulation weakness at early stage before serious damage can occur. Preventive insulation testing of electrical rotating machines, power distribution lines, communication cables, insulators, control and switching equipment etc. is therefore essential to avoid eventual breakdown. SAKOVA Megtester is a robust instrument incorporating a built-in hand driven generator and a solid state circuit for stabilized DC output. The insulation resistance measured is indicated on a logarithmic scale. SAKOVA Megtester meets the requirements of Indian Standard Specification IS: 2992-1980.   FEATURES: SMOOTH GENERATOR: Rotary magnet generator runs smooth with minimum noise because of the excellent dynamic balance of rotating parts. ELECTRONICALLY REGULATED OUTPUT VOLTAGE: Electronic regulation provides excellent long term voltage stability which is not possible with conventional centrifugal clutch mechanisms. OHM METER: The insulation resistance indicated by a moving coil type indicator on a logarithmic scale. QUICK RESPONSE: Quick response saves time and extends life of generator. TECHNICAL SPECIFICATIONS: Measuring Voltages: 100V, 250 V, 500 V, 1000V, 2500V or 5000V. Insulation Ranges: Up to 20,000 Megohms as desired. Accuracy: As per IS: 2992-1980. Casing: Aluminium casted body or Mica Laminated wooden body. Speed of handle: 160 RPM or above. Scale Length: Logarithmic Scale approx. 90 mm long. Dimensions: 220 x 120 x 130 mm approx. (Metal case). Weight: Metal case 2.3 kgs. approx.  
    ...more
  • Climatic Chamber

    Climatic Chamber

    Get Price Quote

    Mirror finished stainless steel inner chamber and cold-rolling steel with static spray plastics exterior * Double door design with built-in tempered glass viewing window * Built in high capacity intelligent humidification system * Automatic water replenishment by external tank * 3-side illumination can be adjusted in five steps * Unique air circulation system ensures temperature uniformity * Programmable microcomputer based PID controller with LCD display
    ...more
  • Emotron M20 Shaft Power Monitor

    Emotron M20 Shaft Power Monitor

    Get Price Quote

    • Brand NameEmotron
    • Range0.4A to 999A
    • Supply220V/400V/525V/690V Single phase / three phase
    • ApplicationFixed Speed Load
    • protection ClassIP20
    • Emotron M20 Shaft Power Monitor helps you save time and money. It protects your pumps and other equipment against damage and detects process inefficiency. Early warnings allow you to take preventive action. Unique features include measuring shaft power output and using the motor as a sensor. The result is reduced maintenance and installation costs, extended equipment lifetime and increased reliability.    Key Features:  Detects over and under load, sends warning or stops the pump.  Uses pump motor as sensor, eliminates need for external sensors.  No moving parts increases reliability.  Shuts pump off before it runs dry. 
    ...more
  • Bursting Strength Tester

    Bursting Strength Tester

    Get Price Quote

    •  SS Pressure Gauge with Testing Report.  Imported Hydraullic Fluid.  Calibration Foil with test Report  Motor with correct RPM & Vibration free Gear Box to give accurate reading  Corrosion Resistance Paint.Green
    • (1) 0 to 7 kg/cm2 (2) 0 to 35 kg/cm2
    • We offer Bursting Strength Tester. Used to determine the bursting strength of paper & paper board. Uniform pressure is produced through electric motor and gear. Pressure measurement by precious bourdon pressure gauge with “peak value indicator” for strong kraft paper, solid fibre & corrugated board specimen is tighted by manual clamping through rotation of wheel handle. Two dial gauges – body mounted pressure gauge. (1) 0 to 7 kg/cm2 (2) 0 to 35 kg/cm2 as per tappi t-807, t-810, astm d2529, d738, as/nz 1301, 438, iso 2759, scan p24, scan p25   salient features :  ss pressure gauge with testing report.  imported hydraullic fluid.  calibration foil with test report  motor with correct rpm & vibration free gear box to give accurate reading  corrosion resistance paint. accessories : (free of cost) extra rubber diaphragm – 2 nos. Reference standard calibration foils for calibration – 2 nos. Standard hydraulic fluid – 400 ml. Spanner for fixing and removing diaphragm – 1 nos.
    ...more
  • Battery Monitoring System

    Battery Monitoring System

    Get Price Quote

    Battery Monitoring System, SMF Batteries, Tubelor Battery, Solar Product
  • Box Compression Tester

    Box Compression Tester

    Get Price Quote

    Box Compression Tester, Testing Equipment, Tensile Teste
  • GSM Tester for Paper

    GSM Tester for Paper

    Get Price Quote

    GSM Tester for Paper, Food Testing Laboratory Equipmen
  • SPM Assembly Air Meter

    SPM Assembly Air Meter

    Get Price Quote

    SPM Assembly Air Meter, Robotic Box Palletizing System, Conveyor
  • Pile Load Tester

    Pile Load Tester

    Get Price Quote

    Pile Load Tester, Ultrasonic Pulse Velocity Tester, Ultrasonic Flaw Detecto
  • Electrical Tester

    Electrical Tester

    Get Price Quote

    Electrical Tester, Bolts, Claw Hammer, Locking Pliers, PVC Tap
  • Universal IC Tester

    Universal IC Tester

    Get Price Quote

    Universal IC Tester, PCB Prototype Machin
Filter by Locality
top