Power Cables Dealers in Noida

Low Tension Control Cable or commonly called as LT Control Cables are one of the most demanded product on our catalogue. These LT Control Cables are manufactured using premium quality raw materials that are sourced from reliable suppliers from across the world. This material is then transformed into highly efficient LT Control Cables by large machines under supervision of skilled workers. This offers our LT Control Cables tremendous flexibility, thermal constancy and high tensile strength. Furthermore, we also test these cables for quality and performance related errors before sending them to clients; this assures delivery of best products from our end. Widely used in under ground and over head transmission of power to the control panels in power plants and other industries.     FEATURES Tremendous flexibility Thermal constancy High tensile strength High conductivity Safe usage Available in varied specifications Cost-effective

XLPE Cables served by us are highly acclaimed in the market for their phenomenal workability. XLPE insulated cables or any others; you can rely on them in any tough conditions put before. Also, when it comes to rates, our XLPE insulated cables are available at the least prices than any other market. We are one of the major XLPE power cables manufacturers in India. BAJAJ-XR Cross Linked Polyethylene Power Cables (XLPE) Different types of cables in the voltage grade 1.1 to 33 kV are being used today in utilities and industries depending on their mechanical and electrical properti~s on one hand and economy in using them in the other. Among these, paper cables, ever since their introduction have been enjoying undisputed acceptability. However, the advent of XLPE cables in the late 70's marked the beginning of a gradual but steady replacement of paper cables especially for higher voltagE; applications. XLPE cables could command an immediate acceptance resulting from their ease of handling, moisture proof sheathing, easier jointing procedures and ease of maintenance. The XLPE range of cables offered by BAJAJ CABLES is known by its brand name BAJAJ-XR. BAJAJ-XR cables of 6.6 kV to 33 kV grade are manufactured as per Indian Standard 7098 (Part II) of 1985. PROPERTIES AND ADVANTAGES OF BAJAJ-XR CABLES The excellent thermal properties of BAJAJ-XR cables permit maximum continuous conductor operating temperature of 90.C and short circuit temperature of 250.e. Moreover, it has very low dielectric loss which does not vary much over the entire operating temperature range. These characteristics, alongwith the low dielectric constant make BAJAJ-XR cables particularly suitable for high voltage applications. Given below are additional outstanding features. High Continuous Current Rating: Its ability to withstand higher operating temperature of 90.C enables much higher current ratings than those of Pve. High Short Circuit Rating: Maximum allowable conductor temperature during short circuit of 250.C is considerably higher than for PVC cables resulting in greater short circuit withstand capacity. High Emergency Load Capacity: BAJAJ-XR cables can be operated even at 130.C during emergency, therefore in systems where cables are installed in parallel, failure of one of two cables will not bring down the system capacity because the remaining cables can carry the additional load even for longer duration until repairs/replacements are carries out. Low Dielectric Losses: BAJAJ-XR cables have low dielectric loss angle. The dielectric losses are quadratically dependent on the voltage. Moreover, these losses occur continuously in every charged cable whether it carries load or not. Hence use of XLPE cable at higher voltages would result in considerable saving in costs. Charging Currents: The charging current are considerably lower permitting dose setting of protection relays. Easy Laying and Installation: Low weight and small bending radii make laying and installation of cable very easy. The cable requires less supports due to low weight. High Safety: High safety against mechanical damage and vibrations. APPLICATIONS Because of the excellent mechanical and electrical properties BAJAJ-XR cables are being used extensively in all power stations and in industrial plants. They are ideally suited for chemical and fertilizer industries where cables are exposed to chemical corrosion or in heavy industries where severe load fluctuations occur and for systems where there are frequent over voltages. Cables can also be used at higher ambicol temperature on account of their higher operating temperature. Their excellent installation properties permit the cable to be used even under most difficult cable routing conditions and also in cramped conditions e.g. city distribution network. Single core cables due to their excellent installation properties are used in power stations, sub-stations and industrial plants with advantage. CONSTRUCTION BAJAJ-XR cables are manufactured and tested in accordance with 15:7098 (Part II) - 1985. Its salient constructional features are as under: Conductor: The conductors m,ade from electrical purity aluminium wires, are stranded together and compacted. All sizes of conductors of single or three core cables are circular in shape. Conductor construction and testing comply to IS: 8130 - 1984. Installation: High quality BAJAJ-XR (XLPE) unfilled insulating compound of natural colour is used for insulation. Insulation is applied by extrusion process and is chemically cross linked by continuous vulcanization process. Shielding: All BAJAJ-XR cables rated above 3.3 kV are provided with both conductor shielding and insulation shielding. Both conductor and insulation shielding consist of extruded semi-conducting compound. Additionally, insulation is provided with semi-conducting tape and non-magnetic metallic tape screen over the extruded insulation. Conductor shielding XLPE insulation and insulation shielding are all extruded in one operation by a special process. This process ensures perfect bonding of inner and outer shielding with insulation. Inner Sheath (Common Covering): In case of multicore cables, cores are stranded together with suitable non-hygroscopic fillers in the interstices and provided with common covering of plastic tape wrapping. As an alternative to wrapped inner sheath, extruded PVC inner sheath can also be provided. Armouring: Armouring is applied over the inner sheath and normally comprises of flat steel wires (strips) for multicore cables. Alternatively, round steel wire armouring can also be offered. Single core armoured cables are provided with non­ magnetic armour consisting of hard drawn flat or round aluminium wires. Outer Sheath: A tough outer sheath of heat resisting PVC compound is extruded over the armouring in case of armoured cables or over non-magnetic metallic tape covering the insulation or over the non-magnetic metallic part of insulation screening in case of unarmoured single core cables. This is always black in colour for the best resistance to outdoor exposure. The outer sheath is embossed the voltage grade and the year of manufacture. The embossing repeats every 300/350 rnrn along the length of the cable. TESTING AND QUALITY CONTROL BAJAJ-XR cables are manufactured under advanced manufacturing and testing facilities. The cables are type tested and routine tested in accordance with IS 7098. The following tests are carried out as routine tests on every length of cable manufactured: Conductor resistance test Partial discharge test High voltage test Test Voltages: Test voltages applied between conductors and screen/armour are shown below in Table.

We are one of the promising Aerial Bunched Cables Manufacturers. The Aerial Bunched Cables (ABC) that we deal in are required for electrical transmission system or a telecommunication line, which is suspended between utility poles or electricity pylons. Aerial Bunched Cables provide safety and reliability compared to other cables. We provide only the best and thus have created repute amid the prominent Aerial Bunched Cables Suppliers in India. 1100 volt Grade Cables are mostly used for distributing power to individual consumers by utility service providers like electricity Bords, electricity distributing authorities. 10000 volts Grade Cables are also use, for the supply of farms, waterworks, transmitters and other facilities outside urban areas. A further common use is the replacement of overhead telecommunication lines, for example, along railway line, by aerial cables as they can be installed on existing poles and make the facility more reliable. Aerial Cable is more valuable for long term economy, safety and reliability overhead conductor. It is better choice for power distribution in densely populated areas where laying the underground cable is either difficult or extremely expensive. Advantages :-  ►  Easly Installation in uraban,congested, or forest area.  ►  Saving in cost .  ►  Human Safety in case of accidental contacts.  ►  Water proof System.  ►  Multiple circuits of Power and Telephone cables could be strung in the same set of poles. Conductor Phase of lighting conductor : Hard drawn Aluminium H2 or H4 grade as per IS : 8130. Messsenger Conductor : Aluminum Silica & Magnesium Alloy used as per IS:398 Insulation Ratansiri Communications Aerial Bunched Cables are mainly available in XLPE applied by extrusion process. Color Insulation Ratansiri Communications Aerial Bunched Cables are mainly available in carbon black. Because the cable remains exposed to sunlight and environment. FR Insulation FR PVC insulation has better fire retardant properties than normal PVC. This FR PVC compound has a high oxygen and temperature index. The wires are wadded with a flame retardant (FR) PVC compound, which helps to control the spread of fire even at very high temperature. It also protects against electrical shock and short circuit.   Construction  ►  3 Aluminium conductor, insulated with XLPE Insulation.  ►  1 Aluminium conductor with XLPE Insulation (optional).  ►  One messenger Al-Alloy Conductor(Base or Insulated).

Specifications We provide all types of cables & connectors used in computer, laptops, printers, cctv camera's. Eg. VGA cable, HDMI cable etc. Computers are all about connectivity and are loaded with cables--both internally and externally--that allow data to be exchanged between the computer's components and peripherals.   Power Cable   Desktop computers typically use a universal power cord for power, while laptops use power adapters, often made to the specifications of the manufacture.   VGA and DVI   VGA and DVI cables use a series of pins to transfer video signals between devices, such as a monitor and the computer. VGA is analog, and DVI is digital.   IDE and SATA   IDE and SATA cables transfer data between the computer's internal components and the motherboard. The cables are pretty much the same as far as speed is concerned.   USB and FireWire   USB and FireWire cables allow peripherals to connect to your computer and transfer data at high speeds. FireWire cables can send and receive data at the same time, while USB cables cannot.   Ethernet   Ethernet cables are used to join two network devices. The cable contains four thin wires that allow data to be transferred at high speeds between the devices in the form of a series of electrical pulses.

Low Tension Control Cable or commonly called as LT Control Cables are one of the most demanded product on our catalogue. These LT Control Cables are manufactured using premium quality raw materials that are sourced from reliable suppliers from across the world. This material is then transformed into highly efficient LT Control Cables by large machines under supervision of skilled workers. This offers our LT Control Cables tremendous flexibility, thermal constancy and high tensile strength. Furthermore, we also test these cables for quality and performance related errors before sending them to clients; this assures delivery of best products from our end. Widely used in under ground and over head transmission of power to the control panels in power plants and other industries; these cables have earned us Kenya,Nigeria,Qatar,Zealand,Taiwan among the elite LT Control Cable Manufacturers and suppliers from India.

Semi conductive screen material is divided into two categories: cross-linking semi-conductive shielding compounds and thermoplastic semi-conductive shielding compound. Mainly applied to shielding of medium & low voltage power cables, and production of semi-conductive shielding for 10KV aerial cables( Used with silane aerial materials). Processing temperature of the cress-linking semi =-conductive shielding compounds: 70-110ºC; Processing temperature of the thermoplastic semi-conductive shielding compounds: 90-140ºC.

Awire is a single or typically cylinder-shaped flexible component of metal. These are generally used to bearm mechanical loads or electricity and telecommunications signals. An electrical cable comprises two or more wires consecutively side by side and attached, warped, or interweaved together to form a single assemblage, the ends of which can be associated to two devices, enabling the transmission of electrical signals from one device to the other quickly and easily. Cables are used broadly in electronic devices for power and signal circuits.     Since beginning we are top supplier of wires and cables. We have the best collection of cables and wires. We offer all range of cables and wires including Aluminum Power cable, Copper Controlled cables, Copper flexible cables, Fire survival cables, Solar Cable, Specialty cable and many more to add in the list. We are adamant to establish a long term service with our client so that’s we don’t only sell but also offer best in class after sales service so that you can stay happy and have a smile on your face.   We provide top notch price and warranty for your choice of products so that you can continue your work and stay away from any manufacturing trouble.

Owing to the efforts of our dedicated procurement team, we are able to bring forth reliable LT-HT Control Cables for the buyers. Due to non-inflammable nature, shock resistance, excellent insulation and high electrical conductivity, our LT HT Power And Control Cables are extensively demanded. Place an order with us; we assure the urgent as well as bulk orders are delivered within the promised time period. From Uttar Pradesh, we are the notable Supplier and Distributor of LT-HT Control Cables.

Unarmoured Cables, Armoured Cable, Three Core Cable

Power Cords Cables, TRANSFORMERS CHOKE COIL

ACSR Conductor Cable, Aerial Bunched Cables, Copper Conductor